泡塑吸附—等离子体质谱法测定金含量的地方标准制定  

MAKING OF LOCAL STANDARDS FOR DETERMINATION OF GOLD CONTENT BY FOAM PLASTIC ADSORPTION-ICP-MS

作　　者：冯玲玲[1] 刘军[1] 孙月婷[1] 

机构地区：[1]安徽省地质实验研究所,安徽合肥230041

出　　处：《安徽地质》2017年第1期68-73,共6页Geology of Anhui

基　　金：安徽省公益性地质(科技)项目<安徽省区域地球化学调查样品分析方法地方标准制定>(项目编号:2011-K-26)支助

摘　　要：开展安徽省区域地球化学样品地方检测标准方法的研究和编制,将能填补我省目前缺乏相关标准的空白,按照地方标准制定的技术路线和方法来优化泡塑吸附—ICP-MS法金含量的测定方法,得到方法检出限为0.140 ng/g,重复性限r=0.2092m+0.9503,再现性限R=0.4948m-0.1478,适用范围为0.82~108 ng/g。所测Au含量在上述范围内,试验中共检测到2个歧离值,但在分析中予以保留。正确度评价采用精密度实验数据和相关统计量数据。对于四个水平,分析方法偏倚的置信区间包含0,表明在置信水平α=5%下偏倚不显著。|△lg C|都小于0.1,符合《地质矿产实验室测试质量管理规范》(DZ/T0130)要求。经过准确度的验证实验说明该标准方法(审批稿)是正确、实用的,可以作为地方标准进一步推广。It will fill in a gap to carry out study and preparation of local detection standards and methods for regional geochemical samples in Anhui Province. According to foam plastic adsorption-ICP-MS gold content determination method optimized by the technical route and method made by local standards, the obtained detection limit is 0.140 ng/g, repeatability limit r=0.2092m＋0.9503, reproducibility limit R=0.4948m-0.1478, and applicable range 0.82 - 108 ng/g. The determined Au content is within the above ranges, in total 2 straggling values were found and reserved in analysis. Accuracy assessment was based on precision test data and relevant statistical magnitude data. For 4 levels, the biased confidence interval of the analytical method contains 0, indicating that the bias is not remarkable at confidence level α=5%. ｜AlgC｜ was all less than 0.1, in line with the requirement of Management Norms for Geological and Mineral Test Quality （DZ/TO130）. Test of the accuracy indicated that the standard and method （approved edition） are correct and practical, can be popularized locally.

关 键 词：地方标准 金测定 等离子质谱 准确度 

分 类 号：O657.63[理学—分析化学] P618.50[理学—化学]