Stitch welding of Ti-6Al-4V titanium alloy by fiber laser  

Ti-6Al-4V钛合金光纤激光叠焊（英文）

作　　者：李翠 李斌[2] 吴泽锋 祁小勇 叶兵 王爱华[1,2] 

机构地区：[1]武汉华工激光工程有限责任公司激光先进制造技术湖北省重点实验室,武汉430223 [2]华中科技大学机械科学与工程学院,武汉430074

出　　处：《Transactions of Nonferrous Metals Society of China》2017年第1期91-101,共11页中国有色金属学报（英文版）

基　　金：Project(2012BAF08B02)supported by Key Project in the National Science and Technology Pillar Program During the Twelfth Five-year Plan Period,China

摘　　要：Stitch welding of plate covered skeleton structure of Ti-6Al-4V titanium alloys has a variety of applications in aerospace vehicle manufacture. The laser stitch welding of Ti-6Al-4V titanium alloys was carried out by a 4 kW ROFIN fiber laser. Influences of laser welding parameters on the macroscopic geometry, porosity, microstructure and mechanical properties of the stitch welded seams were investigated by digital microscope, optical microscope, scanning electron microscope and universal tensile testing machine. The results showed that the three-pipe nozzle with gas flow rate larger than 5 L/min could avoid oxidization, presenting better shielding effect in comparison with the single-pipe nozzle. Porosity formation could be suppressed with the gap between plate and skeleton less than 0.1 mm, while the existing porosity can be reduced with remelting. The maximum shear strength of stitch welding joint with minimal porosity was obtained by employing laser power of 1700 W, welding speed of 1.5 m/min and defocusing distance of ＋8 ram.Ti-6Al-4V钛合金蒙皮和骨架叠焊在航空航天器制造领域有着广泛应用。采用4 k W ROFIN光纤激光器对其进行激光叠焊,利用数码显微镜、光学显微镜、扫描电镜和万能试验机研究激光焊接工艺参数对叠焊焊缝几何尺寸、气孔数量、显微组织和力学性能的影响。结果表明,三管侧吹保护气嘴优于单管侧吹保护气嘴,气流量≥5 L/min时可获得无氧化的焊缝;间隙控制在0.1 mm范围内能有效抑制气孔生成,重熔能有效地减少焊缝中已有的气孔;当激光焊接功率、焊接速度和离焦量分别为1700 W、1.5 m/min和+8 mm时可制得气孔最少、剪切强度最高的叠焊接头。

关 键 词：Ti-6Al-4V titanium alloy fiber laser stitch welding welding parameter POROSITY 

分 类 号：TG456.7[金属学及工艺—焊接]