高速电弧喷涂Fe-Cr-B-C-Al涂层的组织结构及其高温腐蚀行为  

Microstructure and High-temperature Corrosion Behavior of Fe-Cr-B-C-Al Coating Prepared by High Velocity Arc Spraying

作　　者：李柏涛[1] 师玮[1] 乔磊[1] 吴玉萍[1] LI Bai-tao SHI Wei QIAO Lei WU Yu-ping(College of Mechanics and Materials, Hohai University, Nanjing 211100, China)

机构地区：[1]河海大学力学与材料学院,南京211100

出　　处：《理化检验（物理分册）》2017年第4期240-243,248,共5页Physical Testing and Chemical Analysis(Part A:Physical Testing)

摘　　要：采用高速电弧喷涂技术在20G钢基体上制备了Fe-Cr-B-C-Al涂层。采用光学显微镜、扫描电镜、能谱仪、X射线衍射仪、万能材料试验机以及硬度计研究了涂层的微观组织结构和力学性能;然后在650℃条件下进行了涂层的高温腐蚀试验,并与20G钢进行了对比,研究了涂层的耐高温腐蚀机理。结果表明:高速电弧喷涂Fe-Cr-B-C-Al涂层呈典型的层状结构,与基体的结合力较强,涂层内氧化物和孔隙较少;在650℃腐蚀100h后,20G钢的腐蚀增重约为涂层的13倍;在高温腐蚀过程中,涂层表面生成了具有保护作用的氧化膜,提高了涂层的耐高温腐蚀性能。The Fe-Cr-B-@A1 coating was prepared on 20G steel substrate by high velocity arc spraying （HVAS） technok^gy. The microstructure and mechanical properties of the coating were analyzed by optical microscope （OM）, scanning election microscope （SEM）, energy dispersive spectrometer （EDS）, X-ray diffractometer （XRD）, universal tensile testing machine and Vickers hardness tester. The high temperature corrosion test was done at 650℃ and compared with 20G steel to study the high-temperature corrosion resistance of the coating. The results show that the HVAS Fe-Cr-B- C-A1 coating had the typical lamellar structure and combined well with the substrate. There were few oxides and pores in the coating. After corrosion at 650℃ for 100 h, the mass gain of the 20G steel was about 13 times of that of the coating. In the process of high-temperature corrosion, the protective oxide film was formed on the surface of the coating, which improved the high-temperature corrosion resistance of the coating.

关 键 词：高速电弧喷涂 Fe-Cr-B-DAl涂层 组织结构 高温腐蚀 

分 类 号：TG174.44[金属学及工艺—金属表面处理]