检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
出 处:《中国机械工程》2017年第9期1009-1015,共7页China Mechanical Engineering
基 金:国家自然科学基金资助项目(51275440);河北省自然科学基金资助项目(E2013203085)
摘 要:基于Hertz接触理论,以精密钢球传动减速机构为研究对象,建立了减速机构啮合副齿面接触分析模型。分析了钢球与摆线槽齿面间的瞬时接触域,在此基础之上,分析输入轴转速、负载对减速机构热特性的影响,得到钢球与齿面间接触域的瞬时生热率和瞬时摩擦温升。分析结果表明:钢球与摆线槽齿面的瞬时接触域是时变接触椭圆;输入轴转速和负载对瞬时生热率和瞬时摩擦温升都有明显影响,但转速的影响更大;瞬时摩擦温升在常规转速下随转速单调递增,在超低转速下随转速先递减再递增。研究结果为精密钢球传动的三维热力耦合分析奠定了理论基础。Based on the Hertz contact theory, a tooth surface contact model was established forward to analyze the instantaneous contact areas and thermal characteristics of reducing mechanisms for precision ball transmissions. The contact patches among the balls and tooth surfaces of cycloidal groove were analyzed, then the effects of the input shaft speeds and loads on the thermal characteristics of reducing mechanisms were investigated. Instantaneous heat generation rates and instantaneous frictional temperature rises among the balls and tooth surfaces were obtained. The results indicate that the instantaneous contact areas among the balls and tooth surfaces of cycloid groove is a time-varying contact ellipse. The input shaft speeds and loads have visible influences on instantaneous heat generation rates and frictional temperature rises, but the influences of speeds are greater. Instantaneous friction temperature rises are monotonically increasing with the increased speeds under the general speed conditions, but in the low speeds, temperature rises are monotonically decreased and then monotonically increased. The results of the study provide a good foundation for three dimensional thermal mechanical coupling analyses of precision ball transmissions.
分 类 号:TH132.4[机械工程—机械制造及自动化]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.145.51.214