检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]安徽工程大学建筑工程学院,安徽芜湖241000 [2]华中科技大学土木工程与力学学院,湖北武汉430074
出 处:《安徽工程大学学报》2017年第2期91-95,共5页Journal of Anhui Polytechnic University
基 金:安徽工程大学校青年基金资助项目(2015YQ06)
摘 要:采用ABAQUS 6.10有限元软件建立薄型沥青混凝土路面的结构模型,计算分析了结构层参数的变化力学响应.结果表明,路表最大弯沉值、底层最大拉应力与面层厚度成反比例关系;基层模量变化对道路结构不同位置处的最大剪应力峰值的影响显著;面层参数(模量、厚度)变化对道路结构底层最大拉应力影响显著.路用性能试验结果表明,辉绿岩、SBS沥青、水泥填料为亚热带季风气候地区最佳薄层沥青混凝土面层的组合方式,该超薄沥青混合料的车辙动稳定度达3 987次/mm,冻融劈裂试验残留强度比为78.97%,超过规范对改性沥青SMA混合料的要求,这为薄层沥青混合料的推广提供了有力参考.The object of this study is to calculate structure layer parameters, the structural model and analyze changes in the mechanical response of the of thin asphalt concrete pavement is established using ABAQUS 6.10 finite element software. The result shows that the maximum deflection value and the maximum tensile stress is inversely proportional to the underlying surface layer thickness; the influence for base modulus of bottom layer tensile stress is more obvious to the extents of above changes for the index of pavement;What's more,the influence of surface layer parameters (modulus and thickness) on the structure of the underlying road maximum tensile stress is very significant road performance test results show that diabase.SBS asphalt and cement filler are the best combination of thin asphalt concrete surface layer in the subtropical monsoon region.The ultra-thin asphalt mixture rutting dynamic stability is up to 3 987 times/mmand freeze-thaw splitting test residual strength ratio is 78.97%,which exceed the standard of modified asphalt SMA mixture and provide a strong reference for the thin layer of asphalt mixture promotion.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222