填充层强度对隧道整体道床病害的影响研究  

Study on the Effect of Filling Layer Strength on the Tunnel Integration Ballast Disease

作　　者：刘大鹏[1,2] 杨晓华[2] 王婧[1] 张红伟[3] 刘恒任 LIU Dapeng YANG Xiaohua WANG Jing ZHANG Hongwei LIU Hengren(Jiangsu Vocational Institute of Architectural Technology, Xuzhou 221116, China School of Highway, Chang＇ an University, Xi＇an 710064, China China Railway Eryuan Enginerring Group Co. ,Ltd. ,Chengdu 610031,China)

机构地区：[1]江苏建筑职业技术学院,徐州221116 [2]长安大学公路学院,西安710064 [3]中铁二院工程集团有限责任公司,成都610031

出　　处：《结构工程师》2017年第3期179-184,共6页Structural Engineers

基　　金：江苏住建厅科技项目(2016ZD81);广西壮族自治区科技攻关项目(桂科攻10124006-10);西安铁路局科研项目(2010GY102)

摘　　要：填充层强度是引起隧道整体道床病害的原因之一,首先分析了填充层在列车动荷载作用下的响应计算理论,然后结合小棕溪隧道采用有限元软件建立了分析模型,分别计算了注浆法加固填充层前后,即两种不同填充层强度时的应变,结果显示注浆加固后的最大应变约为注浆前的十分之一,填充层强度较大时可以改善隧道整体道床的受力状况。同时通过现场实测结果验证了注浆法加固填充层处理整体道床病害的效果,说明采用注浆法增加填充层强度是处理隧道整体道床病害的一种有效方法,为类似隧道病害处理提供了参考。The filling layer is one of the causes of tunnel integration ballast disease. The paper firstly analyzed calculation theory of filling layer response under the train dynamic load, then analysis model was established by finite element software combining with Xiaozongxi tunnel. The strain of two kinds of different filling layer strength were calculated respectively. Results showed that the maximum strain of grouting was about one over ten of the grouting before. The stress state of the tunnel monolithic roadbed can be improved when filling layer strength is larger. The effect of grouting method on the tunnel integration ballast disease was verified by the measured results. It is shown that grouting method which increases filling layer strength is an effective method for the disease, and it provides a reference for the similar tunnel diseases.

关 键 词：填充层 整体道床 隧道病害 有限元分析 注浆 

分 类 号：U457.2[建筑科学—桥梁与隧道工程]