贫铀表面阴极微弧电沉积氧化铝涂层的研究  

Alumina Coating Deposited on Depleted Uranium Surface by a Cathodic Microarc Method

作　　者：王佳佳[1] 帅茂兵[1] 何伟波[2] 莫川[1] 蒋春丽[1] 

机构地区：[1]表面物理与化学重点实验室,四川绵阳621907 [2]中国工程物理研究院,四川绵阳621900

出　　处：《稀有金属材料与工程》2017年第6期1727-1730,共4页Rare Metal Materials and Engineering

摘　　要：以1.0 mol/L Al(NO_3)_3·9H_2O的乙醇溶液为电解液,用阴极微弧电沉积的方法在贫铀表面制备出厚度约为65μm的氧化铝陶瓷涂层。通过扫描电子显微镜(SEM)观察了涂层的表面和截面形貌,通过X射线衍射仪(XRD)及X射线能量色散谱(EDS)分析了涂层的成分以及相组成,通过电化学综合测试系统分析了涂层的电化学腐蚀性能。结果表明:涂层表面粗糙多孔,与基体呈犬牙咬合状结合;涂层主要由α-Al_2O_3和γ-Al_2O_3组成;涂层中含有少量的U元素,表明膜/基界面附近的贫铀基体在微弧放电的作用下也参与了成膜;沉积氧化铝涂层后,样品的腐蚀电流密度降低了2个数量级,耐腐蚀性能得到大幅度提高。An alumina coating with a thickness of 65 μm was prepared on depleted uranium surface by cathodic microarc deposition in 1 mol/L Al（NO3）3·9H2O ethanol solution.The morphology of the alumina coating was observed by SEM,and the composition and phase constituent were analyzed by XRD and EDS.The corrosion resistance was determined by an electrochemical integrated test system.The results show that the porous coating,which is composed of α-Al2O3 and γ-Al2O3,remains a good adhesion to depleted uranium substrate.The coating contains a little uranium element,which confirms that depleted uranium substrate near the coating/uranium interface also takes part in the sintering process of the coating under cathodic microarc discharge.The corrosion current of the coating is reduced by two orders-of-magnitude,which shows a good corrosion resistance.

关 键 词：阴极微弧电沉积 贫铀 氧化铝 陶瓷涂层 

分 类 号：TG174.4[金属学及工艺—金属表面处理]