湿喷丸处理Ti-6Al-4V合金微动磨损行为影响  

Investigation on the Fretting Wear of Ti-6Al-4V Alloy Treated With Wet Peening

作　　者：张新华[1,2,3] 付雪松[4] 盖鹏涛[1,2,3] 李瑞冬[4] 李康[4] 

机构地区：[1]航空工业北京航空制造工程研究所,北京100024 [2]塑性成形技术航空科技重点实验室,北京100024 [3]数字化塑性成形技术与装备北京市重点实验室,北京100024 [4]大连理工大学材料科学与工程学院,大连116085

出　　处：《航空制造技术》2017年第13期44-47,59,共5页Aeronautical Manufacturing Technology

基　　金：国家自然科学基金(51405059);国防基础科研项目(A0520132002);中央高校基本科研业务费专项资金(DUT16RC(4)33);航空科学基金(20153663010)

摘　　要：采用湿喷丸技术对Ti-6Al-4V合金进行表面强化处理,研究了部分滑移、混合滑移和完全滑移等不同状态下钛合金样品的微动磨损行为,从微动状态角度探讨喷丸强化对钛合金微动磨损行为的影响规律。试验结果显示,喷丸处理对于完全滑移状态下Ti-6Al-4V合金的微动磨损行为影响较小;而在混合滑移状态时,喷丸处理使得微动磨痕的塑性变形积累区消失,有效抑制局部疲劳损伤造成的微裂纹萌生。这是因为喷丸引入加工硬化作用使材料表层局部强度提高,进而改善局部疲劳损伤。Wet peening was taken on Ti-6Al-4V titanium alloy as a surface strengthening treatment. Effect of shot peening on fretting wear behavior was investigated under different conditions of partial slip, mixed slip and gross slip. The fretting wear experiment indicates that wet peening has little influence on fretting wear behavior of Ti-6Al-4V titanium alloy at condition of gross slip. However, wet peening can inhibit crack initiation occurred in accumulation of plastic defor- mation zone when the condition is partial slip. It is suggested that the improvement of local yield strength at surface layer by shot peening was the key reason for avoiding local fatigue damage.

关 键 词：湿喷丸 TI-6AL-4V钛合金 微动磨损 局部疲劳 

分 类 号：TG146.23[一般工业技术—材料科学与工程]