检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:许晓笛 李子欣[1,2] 楚遵方[1] 王平[1] 李耀华[1,2] XU Xiao-di LI Zi-xin CHU Zun-fang WANG Ping LI Yao-hua(Key Laboratory of Power Electronics and Electric Drive, Institute of Electrical Engineering, Chinese Academy of Sciences, Beijing 100190, China University of Chinese Academy of Sciences, Beijing 100049, China)
机构地区:[1]中国科学院电力电子与电气驱动重点实验室,中国科学院电工研究所,北京100190 [2]中国科学院大学,北京100049
出 处:《电工电能新技术》2017年第7期12-19,共8页Advanced Technology of Electrical Engineering and Energy
摘 要:由于滤波性能良好,电感-电容-电感(LCL)滤波器被越来越广泛地应用于有源电力滤波器(APF)。对于单台应用的APF来说,一般采用基于并网电流反馈的有源阻尼方法衰减LCL滤波器的谐振尖峰。然而,在多台APF并联运行以提高补偿容量的场合,传统的有源阻尼方法抑制谐振的效果会显著降低,甚至造成系统无法正常运行。本文在推导并联运行APF的LCL滤波器等效模型的基础上,提出一种新型有源阻尼方法。该方法根据系统并联台数对有源阻尼控制器参数进行自适应调整,提高了APF并联运行系统参数的鲁棒性和系统的稳定性。在3台三相四线三电平APF并联运行系统上的仿真和实验结果验证了所提出方法的有效性。Due to its good filtering performance,LCL filter is more and more widely used in active power filters( APFs). For single APF application,the grid current feedback active damping( GCFAD) method is often used to attenuate the resonant spike of the LCL filters. However,when multiple APFs operate in parallel to increase the compensation capacity,the effect of the traditional active damping method is significantly reduced and even cause instability to the whole system. In this paper,a novel active damping method is proposed based on the LCL filter equivalent model of parallel-operated APF. The method adaptively adjusts the parameters of the active damping controller according to the number of the parallel APFs,which improves the robustness and the stability of the parallel APF system. The simulation and experimental results on three three-phase four-wire three-level APF parallel operating system verify the effectiveness of the proposed method.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.117