光催化技术处理丁腈橡胶废气的中试研究  

PILOT STUDY ON TREATMENT OF NITRILE RUBBER WASTE GAS BY PHOTOCATALYTIC TECHNOLOGY

作　　者：成飞龙[1] 张彤[1] 蔺有雄[1] 

机构地区：[1]中国石油天然气股份有限公司兰州石化分公司,甘肃兰州730060

出　　处：《石油化工安全环保技术》2017年第1期45-46,50,共3页Petrochemical Safety and Environmental Protection Technology

摘　　要：根据丁腈橡胶装置产生废气流量大、浓度低的特点,通过对主要废气处理技术进行分析对比认定,光催化技术更适合处理丁腈橡胶废气。通过开展中试试验发现光催化入口温度、光催化入口水含量、紫外光照强度以及废气中的杂质是影响处理效果的关键影响因素。处理后的废气中丙烯腈浓度降至0.5 mg/m^3以下,达到GB 31571-2015对丙烯腈排放限值的要求,可为下一步工业化应用提供设计依据。According to the characteristics of high flow and low concentration of waste gas from nitrile rubber plant,this paper analyzes and compares the main treatment technologies for waste gas. It confirms that the photocatalytic technology is more suitable for the waste gas treatment of nitrile rubber plant. Through pilot test,it was discovered that the photocatalytic inlet temperature,water contentof photocatalytic inlet,ultraviolet light intensity and impurities in the waste gas were the key influencing factors. The concentration of acrylonitrile in the treated waste gas was reduced to below 0. 5 mg / m^3,which reached the requirement of GB 31571-2015 for acrylonitrile emission limit. This provides the design basis for the industrial application in future.

关 键 词：干燥废气 丙烯腈 光催化 影响因素 

分 类 号：X783.3[环境科学与工程—环境工程]