检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:韩继博 武腾飞[1] 赵春播[1] 邢帅[1] 张磊[1] 夏传青 李姝熠 王少峰[1]
机构地区:[1]中航工业北京长城计量测试技术研究所,北京100095
出 处:《光学技术》2017年第4期348-353,共6页Optical Technique
基 金:技术基础科研项目(JSJC201205B003)
摘 要:采用基于平衡光学互相关的超快激光绝对距离测量方法对大气中一段15m的空间距离进行了测量。仿真了不同脉冲宽度、不同光强损耗对平衡互相关信号的影响,理论分析表明脉宽展宽对平衡互相关信号影响较大。采用中心波长为1037nm、重复频率为260MHz的超快激光器光源,搭建了测距系统。实验验证了在脉宽分别为1.44ps、132fs时,对平衡互相关信号的影响,实验结果符合理论分析。研究了不同脉冲宽度对测量分辨力的影响,结果显示,采样时间为5ms,脉宽为1.44ps,测量分辨力不低于50μm;而当脉宽为132fs时,测量分辨力优于5μm。A distance of about 15 mis measured using the method based on the balanced optical cross-correlation technique with ultrafast laser.The effects of varying pulse width and intensity attenuation on the signal of balanced optical cross-correlation are simulated,which shows that the pulse width has greater impact.An ultrafast laser is used to produce measurement pulses whose output spectrum is centered at a 1037 nm wavelength and the pulse repetition rate is initially set at 260 MHz in the measurement system.In the experiments,the change of the signal of balanced optical cross-correlation are discussed when the pulse widths are 132 fs and 1.44 ps respectively,it proves that the results accord with the theoretical simulation.The measurement resolutions are experimentally tested,it reaches 50μm for a 1.44 ps pulse at a sampling rate of 5ms,and it improves to 5μm when the pulse width is 132 fs.
关 键 词:光学测量 绝对距离测量 飞秒脉冲激光 脉冲宽度 平衡光学互相关
分 类 号:TN249[电子电信—物理电子学]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.135.206.125