检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]浙江工业大学海洋学院,浙江杭州310014 [2]浙江工业大学化学工程学院,浙江杭州310014
出 处:《发光学报》2017年第8期1102-1108,共7页Chinese Journal of Luminescence
基 金:国家自然科学基金(21104066);浙江省自然科学基金(LY15B060006)资助项目~~
摘 要:利用荧光分光光度计对处于常温、压力范围为0.1~60 MPa、浓度为10^(-6)mol·L^(-1)的蒽的三维荧光光谱及浓度比为1∶1的蒽-芴、蒽-萘、蒽-菲、蒽-苊、蒽-荧蒽的三维荧光光谱进行了测定,并通过分析不同压力下蒽的荧光峰位置和峰强度的变化来探讨压力对荧光光谱的影响。结果显示,随着压力升高,蒽的荧光峰并未发生漂移,但是荧光强度发生了显著变化。峰位置为250/382 nm的荧光峰在60 MPa时荧光强度达到最大值,相较于常压下,荧光强度增加了13.6%。其他多环芳烃的加入会改变蒽的高压荧光特性,当蒽中加入了萘,峰位置为250/382 nm的荧光峰强度在10 MPa时达到最大值,相较于常压下,荧光强度增加了9.35%。The effects of hydrostatic pressure on the three-dimensional fluorescence spectra (3DFS) of pure anthracene (10-6 mol·L-1) and its mixtures (anthracene-fluorene, anthracene-naphthalene, anthracene-phenanthrene, anthracene-acenaphthene, anthracene-fluoranthrene, and the concentration ratios are 1∶1) were investigated in a pressure range of from 0.1 MPa to 60 MPa at room temperature.The variation of 3DFS under high pressure was revealed by analyzing the positions and intensities of fluorescence peaks with the increase of hydrostatic pressure.It is found that the fluorescence peak shifts are not detected, however, the changes of fluorescence intensities are observed (e.g.anthracene, the fluorescence intensity of peak of 250/382 nm reached its maximum when the pressure was increased to 60 MPa, and the intensity increases 13.6% compared with that of 0.1 MPa).Otherwise, the high pressure fluorescence properties of anthracene are changed profoundly with the addition of other PAHs (e.g.anthracene) is mingled with naphthalene, the fluorescence intensity of peak of 250/382 nm reaches its maximum when the pressure increases to 10 MPa, and the intensity increases 9.35% compared with that of 0.1 MPa.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.145