检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]广西壮族自治区分析测试研究中心,南宁530022 [2]广西壮族自治区辐射环境监督管理站,南宁530022
出 处:《理化检验(化学分册)》2017年第8期914-916,共3页Physical Testing and Chemical Analysis(Part B:Chemical Analysis)
基 金:广西壮族自治区直属公益性科研院所基本科研业务费专项(2014ACZ04);广西科学研究与技术开发计划项目(桂科能1598025-6)
摘 要:铜铟镓硒靶材样品采用硝酸-盐酸(3+1)混合液低温电热板消解,采用电感耦合等离子体原子发射光谱法测定样品溶液中镓的含量。镓、钇的分析谱线分别为417.2,371.0nm,以钇为内标物。镓的线性范围在100mg·L^(-1)以内,方法的检出限(3s)为0.14mg·L^(-1)。方法用于铜铟镓硒靶材样品的分析,加标回收率为97.5%~104%,测定值的相对标准偏差(n=11)为0.31%~1.8%。The sample of CIGS target was digested by the mixture of nitric acid and hydrochloric acid(3+1)with low temperature electricity plate.Amount of gallium in the sample solution was determined by ICP-AES.Analytical spectral lines of 417.2,371.0nm were chosen for the determination of gallium and yttrium respectively.Yttrium was used as internal standard.Linearity range of gallium was found within 100 mg·L^(-1) with detection limit(3s)of 0.14mg·L^(-1).The proposed method was applied to the analysis of samples of CIGS target,giving values of recovery and RSD′s(n=11)in the ranges of 97.5%-104% and 0.31%-1.8% respectively.
关 键 词:电感耦合等离子体原子发射光谱法 铜铟镓硒靶材 镓
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.28