检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
出 处:《钢管》2017年第4期62-65,共4页Steel Pipe
摘 要:利用ABAQUS软件,分析L80钢级HSM-2特殊螺纹接头静态模型和应变率模型对上扣扭矩、应力应变及密封接触压力的影响,并与实测结果进行对比。对比分析结果表明:采用静态模型计算时,其屈服扭矩结果严重偏小,并出现特殊螺纹接头过早到达屈服扭矩的假象,等效塑性应变结果偏大;采用应变率模型计算的屈服扭矩结果比较符合实际,材料屈服强度得到提高;静态模型和应变率模型对密封性能的计算结果基本一致。The effects of the static model and strain rate model used for the L80 HSM-2 premium connection on the calculation of make-up torque, stress strain and sealing contact pressure are analyzed by use of ABAQUS software and the analysis is compared with the experimental cases. The results show that the yield torque is seriously low, the yield torque of the premium connection appears prematurely and the equivalent plastic strain is higher when calculating by the static model, while the yield torque conforms to the actual cases with the material strength increased when calculating by the strain rate model. The calculation results of the sealing performance are basically consistent when calculating either by the static model or by the strain rate model.
关 键 词:油套管 特殊螺纹接头 有限元分析 应变率 上扣扭矩 应力 应变 密封接触压力
分 类 号:TE931.2[石油与天然气工程—石油机械设备] TG142.1[一般工业技术—材料科学与工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.28