检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:胡俊涛[1,2] 冯鹏[1,2] 梅文娟[1,2] 杨劲松[1,2] 胡晟[1,2] 牛永鹏
机构地区:[1]合肥工业大学特种显示技术国家工程实验室特种显示技术教育部重点实验室省部共建现代显示技术国家重点实验室,合肥230009 [2]合肥工业大学光电技术研究院,合肥230009 [3]中航华东光电有限公司,安徽芜湖241002
出 处:《半导体光电》2017年第4期493-497,501,共6页Semiconductor Optoelectronics
基 金:国家"863"计划项目(2012AA011901);国家"973"计划前研专项项目(2012CB723406);国家自然科学基金项目(51573036);中航工业产学研专项项目(CXY2013HFGD207)
摘 要:采用粒径约为10nm的CdSSe/ZnS量子点层作为发光层,制备了叠层结构的量子点发光器件,研究了量子点层厚度对其薄膜形貌及量子点发光二极管性能的影响。原子力显微镜测试结果表明:量子点层过厚时,量子点颗粒发生团聚,且随着厚度的降低,团聚现象减弱;当量子点层厚度和量子点粒径相当时(约为10nm),量子点呈单层排列且团聚现象基本消失;而量子点层厚度低于10nm时,薄膜出现孔洞缺陷。器件的电流-电压-亮度等测试结果表明:量子点发光二极管中量子点层厚度与器件的光电特性密切相关,量子点层厚度为10nm的器件光电性能最优,具有最低的启亮电压4.2V,最高的亮度446cd/m^2及最高的电流效率0.2cd/A。这种通过控制旋涂转速改变量子点层厚度的方法操作简单、重复性好,对QD-LED的研究具有一定应用价值。In this paper, the laminated structure of quantum dot (QD) light emitting devices were made by using CdSSe/ZnS quantum dots with diameter of about 10 nm as the light emitting layer. The influence of the quantum dot layer thickness on the film morphology and the performance of the quantum dot light emitting diodes was investigated. Atomic force microscopy (AFM) results showed that the quantum dots were agglomerated when the quantum dot layer was too thick, and the aggregation phenomenon was weakened with the decrease of thickness. When the quantum dot layer thickness and quantum dot size were equivalent (about 10 nm), the quantum dots were arranged in a single layer and the aggregation phenomenon disappeared. When the thickness of the quantum dot layer was below 10 nm, the film was defective with holes. The experimental results showed that the thickness of quantum dot layer in QD LED was closely related to the photoelectric properties of the devices. The optoelectronic properties of the device with the quantum dot layer thickness of 10 nm were the best. It had the lowest light-up voltage of 4.2 V, the highest brightness of 446 cd/m^2 and the highest current efficiency of 0.2 cd/A. The method of changing the thickness of the quantum dot layer by controlling spin speed was simple and reproducible, and had a certain application value to QD-LED research.
分 类 号:TN312.8[电子电信—物理电子学]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.229