检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]内蒙古科技大学信息工程学院,内蒙古包头014010 [2]煤矿电气设备与智能控制山西省重点实验室,太原024030
出 处:《煤炭技术》2017年第9期192-195,共4页Coal Technology
基 金:内蒙古自治区自然科学基金资助项目(2016MS0515);煤矿电气设备与智能控制山西省重点实验室开放课题基金资助项目(MEI201502)
摘 要:详细介绍了鄂托克旗煤矿电网发生单相接地故障后系统故障特征,并利用零序网络分解法对故障网络进行分析,给出了零序网络接地故障时零序电流向量图,提出了一种基于从保护安装处到故障点的Kirchhoff回路电压定律的测距定位新算法,选择截止频率为100 Hz二阶巴特沃斯低通滤波器作为信号的前置滤波,利用改进的傅立叶算法消除直流偏移。通过PSCAD/EMTDC进行建模仿真,结果表明:该算法选线准确、动作可靠,可以有效提升煤矿供电的安全性。The fault characteristics of the electrical networks of Etuoke Banner mines after single phase to ground fault in power network are introduced in detail. The fault network is analyzed by the method of sequential network decomposition and the vector diagram of zero sequence current in the ground fault of the zero sequence network is given. Proposes a single phase-to-ground fault location algorithm the algorithm uses the Kirchhoff voltage principle from the relay location to the fault location. It chooses the second-order Butterworth low-pass filter of cut-off frequency of 100 Hz as the pre filter of the signal and uses the improved Fourier transforms algorithm to eliminate the DC offset. And modeling and simulation by PSCAD/EMTDC, the results show that the proposed method is accurate and reliable, and can effectively imorove the safety of coal mine oower supply.
关 键 词:煤矿供电系统 Kirchhoff定律 定位算法
分 类 号:TD61[矿业工程—矿山机电] TM862[电气工程—高电压与绝缘技术]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.38