A/O/O工艺处理含油污水的模拟评估  

Simulation evaluation of oily wastewater treatment by A/O/O process

作　　者：牟桂芹[1] 宋项宁 郭亚逢[1] 曹永友[1] 赵乾斌 姚猛[1] Mu Guiqin Song Xiangning Guo Yafeng Cao Yongyou Zhao Qianbin Yao Meng(Sinopec Safety Engineering Institute, Qingdao Shandong266101, China)

机构地区：[1]中国石化青岛安全工程研究院,山东青岛266101

出　　处：《化工环保》2017年第5期538-542,共5页Environmental Protection of Chemical Industry

摘　　要：利用Bio Win 5.0软件建立了某炼油厂A/O/O工艺处理含油污水的数学模型,对其工艺参数进行了评估,并提出了改进建议。经调整部分动力学参数后,模拟结果与实测值吻合度较好,相关系数在0.75~0.81之间,建立的模型可较好反映工艺的运行工况。模拟优化主要针对一级处理装置,在仅考虑NH_3-N和COD去除的情况下,目前装置的工艺参数较合理,若考虑TN,无法实现TN和NH_3-N同时达标。对一级处理装置的模型进行改进后,出水模拟值中COD轻微上升2%,但ρ(NH_3-N)和TN分别下降83%和66%,可有效减轻后续处理装置负荷。A mathematical model for treatment of oily wastewater in a refinery by A/O/O process was established based on BioWin 5.0 software. The operating parameters were evaluated and suggestions for improvement were given. After adjusting part of the kinetic parameters, the simulation results were in good agreement with the measured values, the correlation coefficients were 0.75-0.81, which indicated that the established model could reflect the operation of the process nicely. The simulation optimization mainly focused on the primary treatment unit. When considering NH3-N and COD removal, the current operating parameters were proper. However, if TN removal was needed, this unit could not guarantee TN and NH3-N removal simultaneously. After improving the model of the primary treatment unit, the simulated value of effluent COD increased slightly by 2%, but ρ（NH3-N） and TN decreased by 83% and 66% respectively, which effectively reduced the load of the subsequent treatment unit.

关 键 词：BioWin5.0软件 含油污水 A/O/O工艺 模拟评估 

分 类 号：X703[环境科学与工程—环境工程]