检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:刘佳 张朱武 王海朋 张亚龙 LIU Jia ZHANG Zhuwu WANG Haipeng ZHANG Yalong(College of Chemical Engineering, Fuzhou University, Fuzhou, Fujian 350116, China)
出 处:《福州大学学报(自然科学版)》2017年第5期706-712,共7页Journal of Fuzhou University(Natural Science Edition)
基 金:福建省自然科学基金资助项目(2012J05017)
摘 要:为改善拉幅定型机烘箱内风道的气流分布和喷嘴出口速度不均匀的现象,采用Fluent 14.5软件对风道的流场和压力场进行数值模拟,分析风道的速度矢量图,计算不同位置喷嘴的出口速度.模拟计算结果表明:在风道内等间距安装5块倾斜角为4°的导流板,并调整风道锥角为3°时,可以很大程度改善风道内气流分布和喷嘴出口速度的均匀性,结构优化也较为合理可行.In order to decrease uneven distribution of airflow and nozzle outlet velocity for air duct in stenter oven,velocity field and pressure field of the air duct were numerically calculated by the Fluent 14.5.Moreover,velocity vector graph and outlet velocity of the nozzle in different positions for the air duct were also analyzed.Finally,the numerical simulation indicated that installing five guide plates with 4° title angle in the air duct by same spaced and adjusting taper angle of the air duct to 3°,which could greatly improved distribution of the airflow and the nozzle outlet velocity and make structural optimization more reasonable and feasible.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.200