IFAS工艺强化处理石化废水效果的研究  

Study on Effect of IFAS Process to Treatment of Petrochemical Wastewater

作　　者：王雷 刘军 李光辉[2] 余毅坚 徐兰 陈晓宏 张志航[2] 

机构地区：[1]中石油抚顺石化烯烃厂,辽宁抚顺113006 [2]广州市国千环境与节能技术研究院,广东广州510000 [3]中山大学水资源与环境研究中心,广东广州510000

出　　处：《环境科学与管理》2017年第8期72-77,共6页Environmental Science and Management

基　　金：国家自然科学基金项目(21377170)

摘　　要：采用IFAS工艺对某石化污水处理厂原有的A/O工艺进行强化处理,达到提标改造目的的同时研究不同运行条件对COD、氨氮和总氮处理效率的影响。结果表明:IFAS-A/O反应器A池最佳载体投配比为10%,O池为15%;最适好氧池DO、回流比和HRT分别为1~2.5 mg/L、150%~200%和12 h^18 h。在反应器连续运行30天及HRT减少17%的情况下,与同步运行污水处理厂处理效果相比较,出水COD基本相同,氨氮有一定降低,TN显著降低,满足了《辽宁省综合污水排放标准》(DB 21/1627-2008)中直接排放的水污染物最高允许排放浓度要求。In this study, IFAS process was used to strengthen the original A/O process in a petrochemical wastewater treatment plant.Meanwhile, the influence of different operating conditions on the treatment efficiency of COD, ammonia nitrogen and total nitrogen was studied.The results show that in the IFAS-A/O,the optimum carrier ratio of A reactor is 10%, O tank is 15%, and the optimum aerobic zone of DO, reflux ratio and HRT are 1～2.5 mg/L,150%～200% and 12～18 h.When the reactor run continuously for 30 days and HRT decreased by 17%, compared with the treatment effect of synchronous operation of the sewage treatment plant effluent, CODis basically the same, but ammonia nitrogen having a lower, and TN significantly reduced, meeting the “Liaoning Province Comprehensive Sewage Discharge Standard”（DB21/1627-2008）by the direct discharge of water pollutants maximum emission concentration requirements.

关 键 词：IFAS-A/O 石化废水 提标改造 强化生物脱氮 

分 类 号：X703.1[环境科学与工程—环境工程]