检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:田伟[1] 居来提.买提肉孜 阿迪娜尔.阿布力孜 尼加提.外力 李艳娜[1] 张锐[3] 艾则孜.艾合买提尼亚孜
机构地区:[1]新疆大学机械工程学院,乌鲁木齐830047 [2]新疆医科大学第四附属医院,乌鲁木齐834000 [3]新疆医科大学第六附属医院,乌鲁木齐830054 [4]新疆维吾尔自治区维吾尔医医院,乌鲁木齐830049
出 处:《生物医学工程研究》2017年第4期312-317,共6页Journal Of Biomedical Engineering Research
基 金:国家自然科学基金资助项目(81160542)
摘 要:通过沙疗过程中骨质层变化情况以及有限元仿真的结果,来研究温度对于骨重建的影响。在前人实验的基础上,对于通过CT扫描获得的数据导入到mimics软件中进行模型的建立,整个扫描过程分为四个阶段:建立OA兔模型前、建OA兔模型后、进行沙疗治疗一周后和进行沙疗治疗两周后。把建立好的模型导入3-matic里面进行网格划分,然后把模型导入comsol软件进行传热数值模拟。通过CT扫描数据和传热数值模拟的结果对比发现,骨组织内部产生的热应力随温度升高,而逐渐增大,当温度达到42℃时应力出现最大值,随后随着温度的升高,应力值逐渐减小。温度较高区域,软质骨呈减少趋势,而密质骨和硬质骨的体积增加。沙疗过程中热量传递对于骨重建起到了促进的作用,42℃时的骨重建调节作用最为明显。To study the effects of temperature on bone remodeling by the results of the whole and local changes of bone layer and the finite element simulation. On the basis of previous experiments, the data was imported into Mimics software to build the model through the CT scan. The whole process was divided into four stages : The establishment of OA rabbit modlishment of OA rabbit model, sand therapy for a week and after treatment for two weeks. The good mthe 3 - matic inside and was mesh generation, and then the model was imported into fer. By the CT scan data and comparison of the results of numerical simulation of heat transfer, it was found that bone tissue of internal thermal stress increased with temperature rose, when the temperature reached at 42 C ,maximum stress appeared; then decreased with the increase of temperature stress values. In higher temperature region, soft bone showed a trendhard bone volume increased. Sand treatment in the process of heat transfer for bone reconstructi ment effect and reconstruction of bone is most obvious at 42℃.
关 键 词:维医沙疗 骨重建 生物传热 力学性能 热应力 温度场
分 类 号:R318[医药卫生—生物医学工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222