电解法处理高质量浓度的含镍电镀废水  

Electrolytic Treatment of High Mass Concentration Electroplating Wastewater Containing Nickel

作　　者：解维闵 何东升[1] 黄文杰 吴玉元 陈靖[1] 秦芳[1] 

机构地区：[1]武汉工程大学资源与土木工程学院,湖北武汉430073

出　　处：《电镀与环保》2018年第1期57-60,共4页Electroplating & Pollution Control

基　　金：湖北省自然科学基金资助项目(2014CFB794);武汉工程大学青年基金资助项目(Q201405);武汉工程大学第十二届校长基金资助项目(2017026)

摘　　要：采用电解-捕捉沉淀联合工艺处理含镍电镀废水并回收镍。结果表明:在pH值为9、电解时间为3h、温度为55℃的条件下电解,废水中Ni^(2+)的质量浓度由4 549mg/L降至440mg/L,镍的回收率达到78%左右;在C_3H_6NS_2Na·2H_2O的质量为1.3g、捕捉时间为15min的条件下捕捉Ni^(2+),废水中Ni^(2+)的质量浓度小于1.0mg/L,达到国家排放标准。The combination method of electrolysis and trapping precipitation are used to treat Ni2＋ in the electroplating wastewater containing nickel. The results show that the mass concentration of Niz~ in wastewater is reduced from 4 549 mg/L to 440 mg/L, and the recovery rate of Ni2＋ is about 78% when pH value is 9, electrolysis time is 3 h, and temperature is 55 ℃. Moreover, under the condition that the dosage of C3 H6 NS2 Na · 2H2Ois 1.3 g, the trapping time is 15 min, the mass concentration of Ni2＋ in the wastewater is less than 1.0mg/L, which reaches the national wastewater discharge standard.

关 键 词：电镀废水 NI2+ 电解法 捕捉沉淀法 

分 类 号：X781.1[环境科学与工程—环境工程]