改进硫化物沉淀法处理氨羧配位剂电镀镉废水的研究  

Treatment of Electroplating Wastewater Containing Cadmium by Ammonia Complexing Agent by Improved Sulfide Precipitation Method

作　　者：邵红艳[1] 余海宁[2] 熊小龙 刘定富[4] 

机构地区：[1]贵阳学院,贵州贵阳550005 [2]贵州师范大学,贵州贵阳550002 [3]贵州省能源办,贵州贵阳550001 [4]贵州大学,贵州贵阳550025

出　　处：《电镀与环保》2018年第1期61-63,共3页Electroplating & Pollution Control

基　　金：黔科合J字(2008)2110

摘　　要：采用Na_2S-Al_2(SO_4)_3-PAM体系直接处理氨羧配位剂电镀镉废水,并考察了废水初始pH值、Na_2S的投加量、Al_2(SO_4)_3·18H_2O的投加量及反应时间对处理效果的影响。结果表明:废水初始pH值为7、Na_2S的投加量为5mL/L,在常温下搅拌反应20min;再投加絮凝剂Al_2(SO_4)_3·18H_2O 8mL/L及PAM 3mL/L,继续搅拌反应5min后静置15min。上清液中残余Cd^(2+)的质量浓度为0.03mg/L,达到《电镀污染物排放标准》(GB 21900—2008)中规定的不大于0.05mg/L的要求,同时Cd^(2+)的去除率达到99.9%。Na2 S-Al2 （SO4）3-PAM system is adopted to deal electroplating wastewater containing cadmium by ammonia complexing agent directly. The effects of initial pH value of wastewater, the dosage of Na2S, the dosage of Al2 （SO4）3 · 18H2O and reaction time on the treatment efficiency were studied. Experimental results show that at pH = 7, when the dosage of Na2 S is 5 mL/L, after stirring reaction 20 min at room temperature, 8 mL/L Al2 （SO4）3 · 18H2O and 3 mL/L PAM were added, continue stirring reaction 5 min, and then put it aside for 15 min. The mass concentration of residual Cd2＋ in the supernatant was 0. 03 mg/L, which reaches the requirement of no more than 0. 05 mg/L in GB 21900--2008, and the removal rate of Cd2＋ reached 99.9%.

关 键 词：重金属 氨羧配位剂 电镀镉废水 

分 类 号：X781.1[环境科学与工程—环境工程]