一种矿用开关电源设计  

Design of a mine-used switching power supply

作　　者：林引[1,2] 

机构地区：[1]瓦斯灾害监控与应急技术国家重点实验室,重庆400037 [2]中煤科工集团重庆研究院有限公司,重庆400039

出　　处：《工矿自动化》2018年第2期95-99,共5页Journal Of Mine Automation

基　　金：国家重点研发计划资助项目(2016YFC0801405)

摘　　要：针对现有矿用开关电源存在的谐波电流较大、功率因数较低等问题,采用主动功率因数校正与谐振软开关电源技术设计了一种矿用开关电源,介绍了该电源的设计指标及硬件电路设计方案。试验结果表明:在170V交流输入且输出满载条件下,矿用开关电源输入电流未出现脉冲状,谐波电流小;50℃环境温度下,电源主要器件的最大温度为98.5℃;在输入电压为AC90~265V时,电源功率因数不小于0.96,纹波电压小于30mV,电源效率达86.5%;绝缘耐压试验中绝缘电阻不小于50 MΩ,漏电流低于1mA。For problems of existing mine-used switching power supply such as large harmonic current,low power factor and so on,a mine-used switching power supply was designed by use of technologies of active power factor correction and resonant soft switching.Design indexes of the power supply were introduced as well as design scheme of its hardware circuits.The test results show that under conditions of inputting AC170 Vand outputting full load,the inputting current of the power supply has no pulse and little harmonic current;the max temperature of main components of the power supply is 98.5 ℃ when environmental temperature is 50 ℃;when input voltage is AC90~265 V,power factor of the power supply is not less than 0.96,ripple voltage is less than 30 mV,and efficiency is 86.5%;in test of insulation withstand voltage,insulation resistance is not less than 50 MΩ,and leakage current is less than1 mA.

关 键 词：矿用开关电源 主动功率因数校正 谐振软开关 谐振变换 谐波电流 电磁干扰 功率因数 

分 类 号：TD60[矿业工程—矿山机电]