右转圆曲线处避险车道流出角度与引道长度  

Departure Angle and Approach Length of Truck Escape Ramps Locating in Right Turning Circular Curve

作　　者：宋灿灿[1] 郭忠印[1] 方勇[1] 

机构地区：[1]同济大学道路与交通工程教育部重点实验室,上海201804

出　　处：《同济大学学报（自然科学版）》2018年第2期201-207,共7页Journal of Tongji University:Natural Science

基　　金：山西省交通厅科技项目(2014-1-18)

摘　　要：采用UC-win Road 9.0驾驶仿真平台,对设置于右转圆曲线的紧急避险车道的流出角与引道阈值进行研究.选择方向调整时间、最小转向半径、方向盘转角幅值、方向盘转角频率4个指标对16名驾驶员驶入避险车道的数据进行回归分析,确定各指标与圆曲线半径的定量关系模型.随后,通过二阶聚类的方法缩小了流出角度与引道的设置范围.最后,考虑车辆的横向行驶稳定性,确定了避险车道的设置参数.建议将紧急避险车道设置于半径1 000m及以上的主线处,流出角0°~5°,引道6s设计行程.条件困难时,紧急避险车道可设置于半径600~1 000m的曲线处,流出角0°~5°,引道为9s设计行程,流出角5°~10°,引道为12s设计行程.UC-win Road 9.0 driving simulation was selected to study the departure angle and approach length of the truck escape ramps locating in the right-turning circular curve. Four indexes, adjusting time, minimum turning radius, steering wheel angle amplitude and frequency, were selected and analyzed by regression analysis on the basis of the data of 16 drivers entering the truck escape ramps. Then the quantitative model of each index with the circular curve radius and the departure angle was established. Through the second order clustering method, the setting range of the departure angle and approach length was narrowed. Finally, with a consideration of the lateral stability of errant vehicle, the design parameters of truck escape ramps were determined. Itwas recommended to set truck escape ramps at the main line with radius no less than 1 000 m, and the departure angle was 0° -5° while the approach length was 6 s the design speed travelling length. With the restricted condition, the truck escape ramps could be set at the horizontal curve radius of 600 m-1000 m, and the departure angle was 0°-5° while the approach length was 9 s the design speed travelling distance. The departure angle was 5 °- 10 ° and the approach length was 12 s the design speed travelling distance.

关 键 词：道路工程 紧急避险车道 右转圆曲线 引道长度 流出角度 

分 类 号：U491[交通运输工程—交通运输规划与管理]