检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:鲁先龙 杨文智 郑卫锋 满银 LU Xianlong;YANG Wenzhi;ZHENG Weifeng;MAN Yin(China Electric Power Research Institute, Beijing 100192, China)
机构地区:[1]中国电力科学研究院有限公司
出 处:《工业建筑》2018年第4期84-88,共5页Industrial Construction
基 金:国家电网公司科技项目(GCB17201700149)
摘 要:锚杆间距是山区输电线路岩石群锚基础设计的关键参数,甚至直接决定了山区斜坡地形岩石锚杆基础应用的可行性。通过在4种典型岩石地基中对4种不同材质锚杆群锚和单锚基础抗拔对比试验,得到了不同岩石条件、锚筋材质、锚筋直径和钻孔直径下岩石单锚和群锚基础抗拔荷载-位移曲线。通过引入群锚效应系数,量化分析了锚杆间距对岩石群锚基础抗拔承载性能的影响规律,并给出了设计取值建议。结果表明:岩石群锚基础抗拔承载性能既取决于单锚承载性能,也受岩石地基性质影响。工程设计中岩石群锚基础的锚杆间距宜为3~4倍的钻孔直径,相应的群锚效应系数可根据岩石性质不同取0.8~1.0。Anchor bolt space is the key parameter to the design for anchor foundations in rocks. To some extent,anchor bolt space determines the feasibility of rock anchor foundations on sloping ground in mountainous area. A comparative test for group anchor foundations and single auchor foundation in rocks was carried out in four typical rock subgrade with four kinds of anchor bolt material. The uplift load-displacement behaviours for group anchor foundations and single anchor foundation were analyzed according to different rock conditions,bolt materials,bolt diameters and borehole diameters. The group anchor effect coefficient was used to estimate the bearing capacity for group anchor foundations in rocks. The value of anchor bolt spacing was suggested. It indicated that the bearing capacity of a group anchor foundation was determined not only by bearing capacity of single bolt but also the properties of rock. The anchor bolt spacing of a group anchor should be 3 to 4 times the diameter of borehole and the corresponding group anchor effect coefficients could be recommended within a range from 0. 8 to 1. 0.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.28