检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:刘永权[1,2] 刘新荣[1,2] 谢应坤[3] 余瑜 LIU Yong-quan;LIU Xin-rong;XIE Ying-kun;YU Yu(School of Civil Engineering, Chongqing University, Chongqing 400045, China;National Joint Engineering Research Center for Prevention and Control of Environmental Geological Hazards in the TGR Area (Chongqing University), Chongqing 400045, China;Chongqing Gao Xin Engineering Survey and Design Institute Ltd., Co., Chongqing 401121, China)
机构地区:[1]重庆大学土木工程学院,重庆400045 [2]重庆大学库区环境地质灾害防治国家地方联合工程研究中心,重庆400045 [3]重庆市高新工程勘察设计院有限公司,重庆401121
出 处:《岩土力学》2018年第6期2164-2174,共11页Rock and Soil Mechanics
基 金:国家自然科学基金项目(No.41372356);中央高校基金项目(No.106112014CDJZR200008)~~
摘 要:针对基坑工程中预应力锚索的特点,采用理论推导、算例计算、数值模拟及实例分析的方法,对拉力型、压力型、荷载分散型锚索及锚拉桩上多排预应力锚索的锁定值取值规律进行了探讨。结果表明:由于锚头刚度的差异,拉力型锚索的锁定值宜取规范规定范围的小值,而压力型锚索宜取相应的大值;荷载分散型锚索应分组张拉锁定,各分组钢绞线的锁定值与锚索自由段长度、分散间距及锚头位移有关,且离孔口距离越远,分段承载体锚索锁定值越大;锚拉桩上的多排预应力锚索应考虑锚索的张拉顺序采取不同的锁定值,基于各排锚索张拉锁定后产生的真实锚头位移的差异,上排锚索宜取较小的锁定值,下排锚索宜取较大的锁定值。相关规律可为基坑锚索的张拉锁定施工提供有益的参考。According to the characteristics of prestressed anchor cables in foundation pit, the principles of selecting the locking values of the tensile anchor cable, pressure anchor cable, scattered-load anchor cable and multi-row anchor cable were discussed through the methods of theoretical derivation, analytical calculation, numerical simulation and example validation. Due to the difference in the stiffness of the anchor head, the results show that according to the specification range, the small locking value is adopted for the tensile anchor cable, but the pressure anchor cable requires the large locking value. Scattered-load anchor cables should be tensioned and locked by groups, and the locking value of steel strand in each group is related to the length of the free segment, dispersion distance and displacement of anchor head. The locking value of the segment bearing body increases with the enlargement of the distance away from the orifice. Different locking values are applied for multi-row anchor cables considering the cable tension locking sequence. Based on the difference of the real anchor head displacement after each row anchor cable is locked, the smaller locking value should be adopted for the upper anchor cables, but the larger locking value is for the lower anchor cables. Therefore, the obtained relevant laws can provide useful references for the stretch locking construction of anchor cables in foundation pit.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:18.118.14.81