硅光电倍增器的变温伏安特性及水汽凝结对伏安特性的影响  

Voltage-Current (I-V) Characteristics of SiPM at Different Temperatures and The Influence of Water Condensation on The I-V Characteristics

作　　者：张国青[1] Fabrice RETIERE ZHANG Guoqing;Fabrice RETIERE(Dept. of Physics, School of Science, Xi＇an Polytechnic University, Xi＇an 710048, CHN;Canadian Particle Accelerator Centre（TRIUMF）, Vancouver V6T2A32, CAN)

机构地区：[1]西安工程大学理学院物理系,西安710048 [2]加拿大粒子加速器中心(TRIUMF),温哥华V6T2A32

出　　处：《半导体光电》2018年第3期337-340,共4页Semiconductor Optoelectronics

基　　金：国家自然科学基金项目(11405119)

摘　　要：为了研究硅光电倍增器(SiPM)在低温下能否正常工作,选取了两种典型的SiPM,通过液氮制冷方式,对SiPM在不同温度下的反向伏安特性进行了研究。结果显示,不同SiPM的过偏压范围(V_B^V_b)随温度的变化差别很大,并且微量水蒸气凝结仅对未封装的SiPM伏安特性的V_b^V_B段有明显影响。分析实验结果得出,SiPM正常工作电压的范围在很大程度上受到衬底材料中缺陷和陷阱浓度的影响。在低温下工作的SiPM,要求其衬底材料中缺陷和陷阱的浓度更低。在进行SiPM的低温应用和测量时,应密切监视偏压加在V_b^V_B区间时,器件的电流是否有变化,而不能只观察击穿之前SiPM的漏电情况。In order to study whether the silicon photomultiplier（SiPM）can work properly at low temperatures,the reverse voltage-current（I-V）characteristics of two typical SiPMs were tested and analyzed under different temperatures by liquid nitrogen refrigeration.The results showed that the maximum over-voltage ranges（VB^Vb）of the two SiPMs vary greatly with temperature,and the condensation of trace water vapor only has obvious influence on the I-V characteristics of unencapsulated SiPMs only between breakdown voltage（Vb）and run away voltage（VB）.The SiPMs working at low temperatures require lower concentration of defects and traps.When applying SiPM in low temperature environment,one should not only observe the leakage before breakdown,but also closely monitor the current of SiPM when the bias is in Vb^VB.

关 键 词：硅光电倍增器 多像素光子计数器 伏安特性 水汽凝结 

分 类 号：O436[机械工程—光学工程]