γ射线辐照对高模量碳纤维及碳纤维/氰酸酯复合材料性能的影响  

Effect of γ-ray irradiation on the properties of high modulus carbon fiber and carbon fiber/cyanate ester composites

作　　者：陶积柏 陈维强 张玉生 黎昱 吴晓宏[2] TAO Jibai;CHEN Weiqiang;ZHANG Yusheng;LI Yu;WU Xiaohong(Beijing Spacecrafts,Beijing 100094,China;Department of Applied Chemistry,Harbin Institute of Technology,Harbin 150001,China)

机构地区：[1]北京卫星制造厂有限公司,北京100094 [2]哈尔滨工业大学应用化学系,哈尔滨150001

出　　处：《复合材料学报》2018年第7期1810-1815,共6页Acta Materiae Compositae Sinica

摘　　要：通过模拟空间γ射线辐照环境,采用60 Co-γ射线对高模量碳纤维及其增强的改性氰酸酯复合材料进行辐照,采用SEM和XRD对辐照前后的碳纤维及碳纤维/氰酸酯复合材料进行了分析和表征,研究了复合材料的质量损失率、拉伸性能及层间剪切强度随γ射线辐照剂量的变化规律。结果表明,γ射线辐照能增加碳纤维表面粗糙度;质量损失率随γ射线辐照剂量增大先增加后趋于平缓,但均小于1%;碳纤维/氰酸酯复合材料拉伸性能与层间剪切强度均随γ射线辐照剂量增大先提高后降低,在吸收剂量为5×105 rad时出现最大值,拉伸强度为1 803 MPa,拉伸模量为243GPa,层间剪切强度为72 MPa。By simulating geosynchronous orbit spaceγray irradiation environment,the high modulus carbon fiber and carbon fiber/cyanate ester composites were irradiated by 60 Co-γray.The carbon fiber and carbon fiber/cyanate ester composites were analyzed and characterized by SEM and XRD before and after irradiation.The effects of irradiation on the mass loss rate,tensile strength and interlaminar shear strength were studied.The results show that the mass loss rates increase with the increase ofγray dose and then tend to be gentle,but less than 1%;the tensile strength and interlaminar shear strength of carbon fiber/cyanate ester composites both increase firstly and then decrease with increasing dose,the maximum values occur at 5×10^5 rad with tensile strength of 1 803 MPa,tensile modulus of 243 GPa and interlaminar shear strength of 72 MPa.

关 键 词：Γ射线 高模量碳纤维 氰酸酯 复合材料 质量损失率 拉伸性能 层间剪切强度 

分 类 号：TB332[一般工业技术—材料科学与工程]