检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:唐欣[1] 江志初 张凯峰[1] 谢星宇 TANG Xin;JIANG Zhichu;ZHANG Kaifeng;XIE Xingyu(School of Electrical and Information Engineering,Changsha University of Science and Technology,Changsha 410004,China)
机构地区:[1]长沙理工大学电气与信息工程学院,长沙410004
出 处:《电力系统及其自动化学报》2018年第6期115-119,共5页Proceedings of the CSU-EPSA
摘 要:变流器型电源可附加阻尼控制,为电网提供阻尼、抑制系统低频振荡,然而附加阻尼控制系数过大会引起变流器不稳定。针对这一问题,本文在新型高压直流输电中引入附加阻尼控制的基础上,建立了系统小信号模型;阐明了利用根轨迹附加阻尼控制系数过大影响系统稳定性的机理;进而给出了系统最大阻尼时控制参数的计算方法。最后利用PSCAD软件进行了仿真,仿真结果验证理论分析与计算的正确性。With additional damping control,a converter-based power source can provide damping for power grid and suppress the system's low-frequency oscillation. However,if the additional damping control coefficient is too large,then the converter will become unstable. To solve this problem,an additional damping control is introduced to the novelhigh voltage direct current(HVDC)transmission. On this basis,a small signal model of the system is established. Using the root locus,the mechanism of the influence of the too large additional damping control coefficient on the system's stability is explained,and the calculation method for the control parameters of the system's maximum damping is fur-ther given. Finally,software PSCAD is used to perform simulations,and simulation results verify the correctness of the theoretical analysis and calculation.
关 键 词:低频振荡 电压源换流器 高压直流 阻尼控制 小信号稳定性
分 类 号:TM712[电气工程—电力系统及自动化]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.3