基于Hydsim的高压共轨电控喷油系统喷油特性仿真分析  

Simulation analysis for injection characteristics of electronically controlled high-pressure common rail fuel injection system based on Hydsim

作　　者：朱凌俊[1] 陈国金[1] 冯浩 陈昌[1] 徐龙 娄翔 ZHU Lmg-jun;CHEN Guo-jin;FENG Hao(School of Mechanical Engineering Hangzhou Dianzi University Hangzhou 310018 China)

机构地区：[1]杭州电子科技大学机械工程学院,杭州310018

出　　处：《能源工程》2018年第3期1-7,共7页Energy Engineering

基　　金：浙江省重点研发计划项目(2015C04002);国家自然科学基金资助项目(51405117;51675148;51541507);校内创新实践基地建设项目(JDR201709)

摘　　要：为了深入研究柴油机喷油系统关键结构对喷油特性的影响,运用Hydsim软件建立系统仿真模型,通过改变进出油节流孔和控制活塞的结构参数,分析其对喷油特性的影响。仿真结果表明:随着进油节流孔面积增大,针阀开启速度变慢,落座速度加快;随着出油节流孔面积增大,针阀开启速度加快,落座速度影响不大,在满足喷油要求的前提下出油节流孔面积应取较小值;随着控制活塞直径增大,针阀开启速度变慢,落座速度变快。可以依据针阀升程和喷油率的仿真曲线,选择适当范围的结构参数。In order to explore the influence of fuel injection system key structure of diesel engine power on fuel injection characteristics,a system simulation model was built based on Hydsim. And the influence of structural parameters on injection characteristics was analyzed by changing the structural parameters of the inlet,outlet throttle and control piston. The simulation results showed that the needle open slowly and seat speed with the inlet throttle area increased; under the premise of the fuel injection requirements,the area of outlet orifice should be smaller,because the needle open speed and seated speed had little effect with the outlet throttle area increased,the needle open slowly and seat speed with the diameter of control piston increased. Finally,according to the simulation curves of needle lift and injection rate,the appropriate range of structure parameters were chosen.

关 键 词：高压共轨 喷油系统 喷油特性 Hydsim 

分 类 号：TK402[动力工程及工程热物理—动力机械及工程]