检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:王东峰 王旖旎 于洁 崔伦 王毅[2] WANG Dongfeng;WANG Yini;YU Jie;CUI Lun;WANG Yi(State Grid Shandong Electric Power Corporation,Dongying Hekou Power Supply Company,Dongying 257200,China;State Key Laboratory of Mining Disaster Prevention and Control Co?founded by Shan Dong Provinceand the Ministry,Shan Dong University of Science and Technology,Qingdao 266590,China)
机构地区:[1]国网山东省电力公司东营市河口区供电公司,山东 东营 257200 [2]矿山灾害预防控制省部共建国家重点实验室培养基地(山东科技大学),山东 青岛 266590
出 处:《电力科学与工程》2018年第7期7-14,共8页Electric Power Science and Engineering
基 金:"十二五"国家科技支撑计划资助项目(2012BAB13B04)
摘 要:为了维持电动机起动电流较小的同时增大其起动转矩,在原有的离散变频原理基础上,对调压主电路、保护电路等方面进行了进一步研究,提出了一种改进的异步电机分级离散变频软启动方式。主调压电路采用全控型晶闸管GTO来代替传统的可控硅晶闸管,在电路保护方面,用理想型开关组取代传统的三相断路器,通过搭建MATLAB仿真模型和实物验证,并将仿真结果与实验结果做对比。分级离散变频软起动不仅能减小起动电流,还能有效地提高起动转矩,由二分频向工频过渡时,电流波动较小,过渡平滑,且相同时间内电动机转速也相对较高,在0~0.5s内起动转矩明显增大,最大可达900 N·m,为普通晶闸管离散变频软起动的2~3倍。通过计算并控制某一分频的最优相位角和作用时间,使之平稳过渡到下一分频,即可达到理想的软起动目的。In order to maintain the small starting current and increase its starting torque,on the basis of the original discrete frequency principle,the main circuit and the protection circuit of the voltageregulating system were further studied. An improved asynchronous motor discrete frequency conversion soft start mode was proposed. In the proposed mode,the traditional thyristor is replaced by GTO in the main circuit,and in the protection circuit,the traditional three-phase circuit breaker is replaced by the ideal switch group. By building MATLAB simulation model and through physical verification,the simulation results were compared with the experimental ones. This improved soft startmode can not only reduce the starting current,but also increase the starting torque. When transiting from two-divided frequency to the power frequency,the current fluctuation is relatively small,and the transition is smooth; meanwhile,the motor speed is relatively high. The starting torque increases obviously during 0 ~ 0. 5 s,and the maximum can reach 900 N·M,which is 2 ~ 3 times the traditional one. By calculating and controlling the optimal phase angle and action time of a divided frequency,it can smoothly transit to the next divided frequency to achieve the ideal soft start.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:18.116.15.98