以镁碱代替钠碱的化机浆过氧化氢漂白研究  

A research on the substitution of magnesium hydroxide for sodium hydroxide in hydrogen peroxide bleaching of chemi-mechnical pulp

作　　者：任红锐 王少光 王权科 黄在立 张立芹 郭新 李双晓 REN Hong-rui, WANG Shao-guang, WANG Quan-ke, HUANG Zai-li, ZHANG Li-qin, GUO Xin, LI Shuang-xiao(Shandong Jianghe Paper Co., Ltd., Qihe 251100, Shandong, China)

机构地区：[1]山东江河纸业有限责任公司,山东齐河251100

出　　处：《中华纸业》2018年第14期34-37,共4页China Pulp & Paper Industry

摘　　要：以镁碱部分代替钠碱用于化机浆高浓过氧化氢漂白。通过实验室小试和制浆车间中试对比了钠碱和镁碱对成浆指标、制浆废水电导率的影响。结果表明:以氢氧化镁代替氢氧化钠作碱源,成浆白度相当,吨浆电耗、双氧水单耗略有增加;成浆手抄片抗张指数略有提高,松厚度明显提高,撕裂指数略有降低;制浆废水电导率和COD分别降低15%和10%。Sodium hydroxide can be partly replaced by magnesium oxide in chemi-mechanical pulp bleaching through high-consistency hydrogen peroxide. Through trial tests in both laboratory and plant, comparison between the influence of sodium hydroxide and magnesium oxide was conducted in this paper from pulp properties and waste water conductivity. The results showed that replacing sodium hydroxide by magnesium hydroxide cannot influence pulp brightness. But it could bring about slight increase in power and hydrogen peroxide consumption, improvement of tensile index of pulp sheets, obvious optimization of sheet bulkness, slight reduction of tearing index, and reduction of waste water conductivity and COD by 15% and 10% respectively.

关 键 词：氧化镁 氢氧化镁 氢氧化钠 化机浆 漂白 电导率 COD 

分 类 号：TS745[轻工技术与工程—制浆造纸工程] TS743.2