检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:黄然 束洪春[2] 龚振 王辉春 于宗俊 Huang Ran;Shu Hongchun;Gong Zhen;Wang Huichun;Yu Zongjun(Yunnan Power Grid Electric Power Research Institute,Kunming Yunnan 650217,China;College of Power Engineering,Kunming University of Science and Technology,Kunming Yunnan 650051,China;Pu er Power Supply Bureau,Yunnan Power Grid Co.,Ltd.,Pu er Yunnan 665000,China)
机构地区:[1]云南电网电力研究院,云南昆明650217 [2]昆明理工大学电力工程学院,云南昆明650051 [3]云南电网有限责任公司普洱供电局,云南普洱665000
出 处:《电气自动化》2018年第6期59-62,66,共5页Electrical Automation
摘 要:特高压直流输电线路雷击引起的暂态信号高频分量,是行波保护和暂态保护误动的主要因素之一。输电线路在雷击故障和普通接地短路故障下,因有故障电流入地通路,保护安装处检测到的电压信号的幅值会快速衰减,信号复杂度低;在雷击未故障情况下,不存在故障电流入地通路,保护安装处检测到的电压信号的幅值衰减较慢,信号复杂度高。研究基于多尺度小波变换分析了电压信号频率分量的衰减,用小波能谱熵反映电流或电压频率空间的能量分布信息,实现雷电暂态信号的识别,并通过能量相对熵实现故障极的选择。在EMTP/PSCAD中搭建了±800 k V直流输电模型,仿真结果表明,方案能很好地进行暂态信号的识别,受故障距离、过渡电阻等因素的影响小。Transient signal high-frequency component caused by lightning strokes on ultra high valtage direct current transmission lines is one of the main causes for the malfunction of travelling wave protection and transient protection. In the case of lightening stroke fault or normal grounding short circuit fault of the transmission line,as the fault current has a grounding passage,the voltage amplitude detected at the protection installation attenuates quickly and the signal complexity remains at a low level. If the lightening stroke does not cause any failure,there is no grounding passage for the fault current,the voltage amplitude detected at the protection installation will attenuate slowly,and the signal will have a high complexity. This paper analyzed the attenuation of the frequency component of the voltage signal on the basis of multi-scale wavelet transform. Energy distribution information of current or voltage frequency space was reflected by the wavelet energy entropy to realize identification of lightening transient signal,and faulty poles were selected through relative entropy of energy. A ± 800 kV DC power transmission model was set up in EMTP/PSCAD. Simulation results indicated that the proposed approach could make good identification of transient signal,under little influence of fault distance,transition resistance and other factors.
关 键 词:特高压直流输电 雷电干扰 能量分布信息 小波能谱熵 EMTP/PSCAD
分 类 号:TM773[电气工程—电力系统及自动化]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.7