检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:仇一颗[1] 周祎 周云[1] 易伟建[1] QIU Yike;ZHOU Yi;ZHOU Yun;YI Weijian(College of Civil Engineering,Hunan University,Changsha 410082,China)
出 处:《湖南大学学报(自然科学版)》2018年第3期8-17,共10页Journal of Hunan University:Natural Sciences
基 金:国家自然科学基金资助项目(51178175);国家自然科学基金青年基金资助项目(51208190);教育部高等学校博士学科点新教师基金资助项目(201201611120028)~~
摘 要:对高层建筑结构进行抗震分析时,结构设计软件PKPM通常以周期折减系数来考虑填充墙对结构刚度的影响.以来宾市高层实测项目中8栋高层为研究对象,对其进行随机振动测试并在有限元软件Sap2000中建模,利用实测数据对有限元分析模型进行校验并比较校验前后的抗震分析结果.在Sap2000中建立高层建筑模型并采用与PKPM软件相同的方式考虑填充墙的影响,计算结果表明2种模型具有可比性.利用壳体模型和斜撑模型分别在Sap2000软件中对填充墙进行模拟,并利用现场实测数据对模型进行校验.用Sap2000模型代替PKPM模型进行小震作用下线弹性阶段的地震反应分析,与PKPM软件的计算结果对比后发现相较于修正后的Sap2000模型计算值,PKPM模型计算的未经折减的层间剪力是Sap2000模型的1/2左右,而水平位移和层间位移角却是Sap2000模型的3~4倍.根据JGJ 3-2010《高层建筑混凝土结构技术规程》建议的周期折减系数为0.7~1.0,设计取值更为保守.When structural seismic analysis is conducted on high-rise buildings,the impact of the infill wall stiffness on the structure response is usually considered by the fundamental period the PK RM software.In this paper,eight high-rise buildings in the Laibin High-Rise Testing Project were examined.These buildings were tested for ambient vibration and seismic analysis,which were also modeled and calibrated by the Finite Element(F E)Sap2000 software.F irst,eight F E models buildings were built in Sap2000.The same modeling for infilled wall using PKPM was also calculated,and the comparison of these two calculation results demonstrates the comparability of these two models.N ext,shell model and diagonal strut model were adopted in the modeling of infill wall,and the models were caiibrated by using the data from test.Thereafter,Sap2000 model was used for seismic response of PKPM model.Finally,the seismic response spectrum analysis in linear elastic status was conducted under small earthquake.The comparison of the calculation results from PKPM software compared with the calculated value of calibrated model,the unreduced floor shear force calculated by P K PM is half of that by Sap2000,and the inter story displacement and inter story drift calculated by PKPM is three to four times of that by Sap2000.Moreover,the value of fundamental period by Technical Specification for Concrete Structures of Tall Building(JG J3-2010)is more conservative to the results obtained from the analysis.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.12.164.78