连续/脉冲复合激光光束辐照铝靶材的热特性研究  

Thermal Properties of Aluminum Target Irradiated by Combined CW/pulsed Laser Beam

作　　者：李超[1] 高勋[1] 安良友志 王毕艺[2] LI Chao;GAO Xun;Anliang Youzhi;WANG Biyi(School of Science,Changchun University of Science and Technology,Changchun 130022;Key Laboratory of Electro-optical Information Control and Security Technology,Tianjin 300308)

机构地区：[1]长春理工大学理学院,长春130022 [2]光电信息控制和安全技术重点实验室,天津300308

出　　处：《长春理工大学学报（自然科学版）》2018年第2期1-6,共6页Journal of Changchun University of Science and Technology(Natural Science Edition)

基　　金：国家自然科学基金(61575030)

摘　　要：基于Comsol multiphysics5.0软件对连续/脉冲复合激光光束辐照铝靶材的热作用特性进行了仿真计算,得到了脉冲激光相对连续激光辐照之间的时间延时对连续/脉冲复合激光作用铝靶材的温度时间演化影响。研究结果表明,相对延时0.4s的连续/脉冲复合激光作用条件下,铝靶材表面温度最高达到1932K,熔化深度和熔池半径最大分别为828mm和1.66mm。在相同激光聚焦条件下,达到相同温度和熔化深度,连续/脉冲复合激光需要的激光总能量均低于单一连续激光作用能量。研究结果对连续/脉冲复合激光用于提高激光加工效率具有重要意义。The thermal properties of aluminum target irradiated by combined continuous and pulsed laser beam(combined CW/Pulsed laser beam)were simulated based on Comsol multiphysics5.0 software,and the temperature time evolution and phase transition process of aluminum target were affected by delay time between continuous and pulsed laser beam.The simulation results show that the surface temperature of aluminum target is up to 1932K,the maximum melt depth and the radius of molten pool are 828mm and 1.66mm respectively,under the conditions of irradiated time of 1s with delay time of 0.4s.The required Laser power of combined continuous and pulsed laser beam is lower than that of single continuous laser to get the same temperature and melting depth under the same laser focusing conditions.The physical reason is that the continuous laser power deposited into the target is increased due to the pulsed laser effect.The research results are of great significance to the improvement of laser processing efficiency by using combined continuous and pulsed laser beam.

关 键 词：连续/脉冲复合激光 时间延时 热作用 仿真计算 

分 类 号：O437[机械工程—光学工程]