检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:蒋美琴[1] 陈兵 潘晶[1] 刘新才[1] JIANG Meiqin;CHEN Bing;PAN Jing;LIU Xincai(Faculty of Materials Science and Chemical Engineering,Ningbo University,Ningbo 315211,China)
机构地区:[1]宁波大学材料科学与化学工程学院,浙江宁波315211
出 处:《功能材料》2018年第4期4139-4143,共5页Journal of Functional Materials
基 金:国家自然科学基金资助项目(51274125;51174121);浙江省重点科技创新团队资助项目(2012R10016-08)
摘 要:使用X射线衍射、扫描电镜和磁滞回线仪等研究热变形温度、平均片状晶长度、单畴晶粒占比、平均片状晶厚度对热变形Nd_(14)Fe_(80)B_6磁体矫顽力的影响。结果表明,当Nd_(14)Fe_(80)B_6热变形温度超过其富稀土晶界相熔点150~170K后,磁体矫顽力从737kA/m降低到355kA/m。热变形Nd_(14)Fe_(80)B_6磁体统计平均片状晶长度L为320~500nm,单畴晶粒占比0.52~0.26,多畴晶粒的增加是热变形磁体矫顽力下降的原因。随着热变形温度的增加、变形时间的延长,平均片状晶厚度增长速度快于平均片状晶长度,对应热变形磁体矫顽力的下降。若降低变形温度在富稀土晶界相熔点附近有望提高磁体的矫顽力。Effects of deformation temperatures,average platelet-grain length,single domain grain ratio and average thickness of platelet grain on coercivity of Nd14Fe80B6 die-upset magnets were investigated with X-ray diffraction,scanning electron microscopy and hysteresis loop instrument.The results show that when Nd14Fe80B6 die-upset temperature is 150-170 K above the melting point of its rich-rare-earth boundary phase,the coercivity of magnets decreases from 737 to 355 kA/m.The average platelet-grain length ranges from 320 to 500 nm and single domain grain ratio changes from 0.52 to 0.26.The increase of multi domain grains is the main cause of the coercivity decreasing.As the deformation temperature increasing or deformation time prolonging,the thickening velocity is higher than the length increasing speed of the platelet grains,resulting in the decrease of coercivity.If the deformation temperature is reduced near to the melting point,the coercivity of the die-upset magnets would be improved.
关 键 词:热变形 矫顽力 平均片状晶长度 单畴晶粒占比 平均片状晶长厚比
分 类 号:TG113.225[金属学及工艺—物理冶金]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.13