面向家族制模具多异型腔不平衡充填的快速优化设计  

Rapid Optimum Design of Family Mould with Multiple Special-shaped Cavities for Unbalanced Filling

作　　者：李光明[1] 郑丽璇[1] 要小鹏 LI Guangming;ZHENG Lixuan;YAO Xiaopeng(School of Manufacturing Science&Engineering,Southwest University of Science and Technology,Mianyang 621010,China;School of Medical Information and Engineering,Southwest Medical University,Luzhou 646000,China)

机构地区：[1]西南科技大学制造学院,四川绵阳621010 [2]西南医科大学医学信息与工程学院,四川泸州646000

出　　处：《中国塑料》2018年第10期87-92,共6页China Plastics

基　　金：四川省科技厅软课题项目(2018ZR0074);四川省教育厅项目(16ZB0138);西南科技大学博士基金(11ZX7108)

摘　　要：由于家族制模具多异型腔结构的不平衡性,极易在注射成型过程中产生局部充填不满、迟滞效应等缺陷,很大程度上制约着制品的品质。在对塑料熔体流动分析的基础上,发现流道截面半径和长度是影响熔体体积流量和压力分布的重要因素。针对指示灯柱产品多异型腔组合结构的注射成型特征,提出将不同型腔间充填末端的最大平均压力差作为不平衡因子,集成一种基于均匀设计多维结构变量的快速优化机制,结合遗传算法全局优化获得指标最优的流道方案。模拟验证结果表明,结构参数改进后的流道系统充填平衡效果明显优于初始结果。Due to the imbalance of multiple special-shaped cavities in the family mould,there are some defects such as short shot and delaying effect easily caused during the injection molding process.This results in a poor quality of the formed products.Based on the melt flow analysis,the section radius and length of the runner were determined as two important factors affecting the volume flow and pressure distribution of the melt.Considering of the complex mold structures for indication lamp post,the maximum difference of filling pressures at the end of filling process among different sub-runner was taken as an unbalance factor,and an integrated rapid optimum mechanism with a multivariate structure variety was constructed according to the uniform design method.The optimal runner scheme was obtained by combining with the global optimization of the genetic algorithm.The numerical simulation results indicated that the runner system with improved structure parameters has a better balance filling effect than that with the initial ones.

关 键 词：家族制模具 多异型腔 充填不平衡 快速优化机制 

分 类 号：TQ320.662[化学工程—合成树脂塑料工业]