传统制梯形槽电枢冲片法的不足及完善措施  

Insufficiency and improvement measures of traditional manufacturing method of trapezoidal slot armature stamping

作　　者：蒋昕 张宇 张跃江 JIANG Xin;ZHANG Yu;ZHANG Yuejiang

机构地区：[1]贵州航天林泉电机有限公司,贵州贵阳550003 [2]国家精密微特电机工程技术研究中心,贵州贵阳550003

出　　处：《现代机械》2018年第6期45-49,共5页Modern Machinery

摘　　要：以一台某型号无人机用舵电机为例,阐述了传统作圆求点制梯形槽电枢冲片法,通过对比以作圆求点法所制梯形槽与以Ansoft计算所得理想梯形槽差异,分析差异对电机槽满率、热负荷、磁密、负载效率等性能的影响。结果表明,以作圆求交点法所制梯形槽比理想梯形槽槽满率高、绕线工艺性差、电机热负荷大、电枢齿部磁密高,电机额定点负载效率低。最后,提出以作平行线求交点法制理想梯形槽电枢冲片的完善措施。Taking a rudder motor of a certain type of UAV as an example,the traditional method of making trapezoidal slot armature stamping-circle for point method is described.The trapezoidal slot made by the circle method and the ideal trape-zoidal slot calculated by Ansoft are compared.The influence of the difference between the two on the performance of motor slot fulling factor,heat load,magnetic density and load efficiency is analyzed.Compared with the ideal trapezoidal slot,the trapezoidal slot made by circle intersection method has the advantages of high slot fulling factor,poor winding process,large thermal load,high magnetic density of armature teeth and low load efficiency at rated points.Finally,the improvement meas-ures for making trapezoidal slot armature stamping by parallel line intersection method are proposed.

关 键 词：作圆求点法 梯形槽Ansoft 差异 作平行线求交点法 

分 类 号：H02[语言文字—语言学] K1502[历史地理—历史学]