臭氧耦合PAM预处理褐煤气化废水的影响因素研究  

Study on influencing factors of pretreatment of lignite gasification wastewater by coupling ozone and polyacrylamide

作　　者：王金龙[1] 陆曦[1,2] 于杨 张晓东 徐炎华 WANG Jinlong;LU Xi;YU Yang;ZHANG Xiaodong;XU Yanhua(School of Environmental Science and Engineering,Nanjing Tech University,Nanjing 210009,China;NJTECH Environment Technology Co. Ltd.,Nanjing 210009,China;Shanxi Wiser Technology Institute Co. Ltd.,Taiyuan 030000,China)

机构地区：[1]南京工业大学环境科学与工程学院,江苏南京210009 [2]南京工大环境科技有限公司,江苏南京210009 [3]山西华仕低碳技术研究院有限公司,山西太原030000

出　　处：《南京工业大学学报（自然科学版）》2019年第1期47-51,共5页Journal of Nanjing Tech University(Natural Science Edition)

基　　金：山西省科技重大专项(MH2015-08)

摘　　要：采用O_3耦合聚丙烯酰胺(PAM)法对褐煤气化废水进行预处理,考察pH、反应温度、搅拌时间、PAM投加量等因素对处理效果的影响。结果表明:各因素对处理效果的影响由大到小的顺序为反应温度、pH、PAM投加量和搅拌时间。最佳酸沉条件为反应温度40℃左右,pH≈3,PAM投加量0. 5 mg/L,搅拌时间约1 min。反应后化学需氧量(COD)去除率为12. 7%,产生的沉渣量为0. 33 g/L,254 nm处吸光度去除率为56. 0%,410 nm处吸光度去除率为21. 4%。预处理有效地去除废水中含有的大分子不饱和有机物,能够为后续生化氧化处理提供良好条件。The effects of ozone and polyacrylamide(PAM)on the pretreatment of lignite gasification wastewater were investigated.The factors were pH,reaction temperature,stirring time and PAM dosage.Results showed that influence degree rank of treatment efficiency was reaction temperature,pH,PAM dosage and stirring time.The optimum conditions were 40℃,pH≈3,0.5 mg/L PAM and 1 min stirring time.Results indicated that after pretreatment,the removal of chemical oxygen demand(COD)and sediment amount were 12.7%and 0.33 g/L,respectively.The removal of absorbance of 254 nm and 410 nm was 56.0%and 21.4%,respectively.After pretreatment,large molecular unsaturated organic substances were removed,and remaining wastewater were better for the subsequent biochemical oxidation treatment.

关 键 词：臭氧氧化 褐煤气化废水 聚丙烯酰胺 混凝沉淀 

分 类 号：X703[环境科学与工程—环境工程]