检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:陈才星 牛慧昌[1] 李钊[1] 李磊[1] 莫善军[2] 黄鑫炎 CHEN Caixing;NIU Huichang;LI Zhao;LI Lei;MO Shanjun;HUANG Xinyan(Institute of Industry Technology, Guangzhou & Chinese Academy of Sciences, Guangzhou 511458, Guangdong, China;School of Engineering, Sun Yat-sen University, Guangzhou 510006, Guangdong, China;Department of Building Services Engineering, The Hong Kong Polytechnic University, Hong Kong, China)
机构地区:[1]广州中国科学院工业技术研究院新能源热安全工程技术研究中心,广东广州511458 [2]中山大学工学院,广东广州510006 [3]香港理工大学火灾工程研究中心
出 处:《储能科学与技术》2019年第3期532-537,共6页Energy Storage Science and Technology
基 金:广东省科技计划项目(2015B010118001)
摘 要:动力电池热失控扩展阻隔是抑制大规模电池火灾的重要途径。本文采用环氧树脂板(ERB)阻隔锂离子电池的热失控扩展,分析不同厚度ERB对串联及并联模组的热失控阻隔作用。结果表明,ERB可降低热失控电池模组的最高温度,减轻电池热失控剧烈程度,避免喷射火焰的产生;对于并联的电池模组,采用2 mm ERB的锂电池模组的电池间热失控扩展平均时间间隔为198s,为无ERB时的2.29倍,采用4mmERB时平均时间间隔延长至无ERB时的5.57倍;对于串联的电池模组,采用2 mm ERB时电池热失控扩展平均时间间隔延长至无ERB锂电池模组的2.09倍,采用4 mm ERB时可完全阻止热失控扩展;研究发现并联的电池模组相对于串联模组更容易扩展,其原因为并联模组单个电池热失控时会形成电回路并产生焦耳热。Fires and explosive hazards of lithium-ion batteries resulted from thermal runaway (TRA) propagations presented threats on the public safety. In order to prevent large-scale hazard of battery systems, one effective method is TRA mitigation. In this work, epoxy resin board (ERB) was applied to mitigate the TRA propagation of prismatic battery modules. It was found that ERB can lower the highest temperature of the battery module, mitigate the TRA severity of the batteries, and avoid the generation of the jet flames. For the module with parallel electric connection, the average TRA propagation time was 198 s per battery number when 2 mm ERB was applied, which was 2.29 times compared to that without ERB. And it was extended to 5.57 times when 4 mm ERB was used. For the module with series electric connection, the average thermal runaway propagation time was extended to 2.09 times with 2 mm ERB applied. While TRA propagation was prevented when 4 mm ERB was used, which meant thermal runaway was more easily propagated in module with parallel connection than that with series connection, because of the additional joule heat caused by the formed electrical circuit.
分 类 号:TM911[电气工程—电力电子与电力传动]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.145