车载快速充电适配器的安全与标准的研究  

Research on Safety and Standard of the Quick Car Charge

作　　者：王成涛 张辉 陈华平[2] 徐蓓蓓[2] 黄晓东[2] 马菁菁[2] 徐嵘[2] WANG Chengtao;ZHANG Hui;CHEN Huaping;XU Beibei;HUANG Xiaodong;MA Jingjing;XU Rong(Shenzhen Institute of Inspection and Quarantine, Shenzhen, Guangdong, 518033, China;The Testing and Technology Center for Industrial Products)

机构地区：[1]深圳市检验检疫科学研究院,广东深圳518033 [2]深圳出入境检验检疫局工业品检测技术中心

出　　处：《检验检疫学刊》2019年第2期65-67,共3页Journal of Inspection and Quarantine

基　　金：深圳市电动平衡车公共检测和技术咨询公共技术服务平台项目(GGW2017041217343002)

摘　　要：随着芯片技术的发展和应用,车载快速充电适配器行业得到飞速发展。但车载适配器一直沿用的行业标准是2011年颁布的YD/T 2306—2011 《移动通信终端车载直流电源适配器及接口技术要求和测试方法》[1]。本文通过对现行快速充电适配器的技术特点开展分析,对行标中的测试方法进行了研究,指出了测试方法亟待更新的要点,并指出更新测试方法的根本在于对测试负载的选择。With the development of IC, the Quick Car Charge also has a fast development, but the standard YD/T 2306-2011 Technical Requirements and Testing Method of DC Power Supply Adapter and Interface for Mobile Communication Terminal Vehicle was issued at 2011, and there are several regulations in the standard which are not suitable to supervise the new technology. In this paper, it gives a detail analysis about the basic conflict between standard and the new technology of quick car charge, and points out that the solution is to select a suitable testing load.

关 键 词：车载 快速充电 测试方法 测试负载 

分 类 号：TM46[电气工程—电器]