3维曲面振镜激光加工FPLSCM算法实践  被引量:3

Application of FPLSCM algorithm in laser process of 3-D curved-faces based on galvanometers

在线阅读下载全文

作  者:杨航 刘晓东[1] 李君豪 卢敏健 YANG Hang;LIU Xiaodong;LI Junhao;LU Minjian(National Engineering Research Center for Laser Processing, Huazhong University of Science and Technology, Wuhan 430074, China)

机构地区:[1]华中科技大学激光加工国家工程研究中心

出  处:《激光技术》2019年第4期482-487,共6页Laser Technology

摘  要:为了高质量地将目标图像标刻在任意曲面上,需要将计算机中排版的2维数据转换为3维数据从而形成具体振镜加工轨迹数据.在大量激光标刻实验测量与计算的基础上,采用一种对任意自由曲面进行最小化失真展开的区域重点最小二乘共形展开(FPLSCM)算法,完成了实用的3维振镜激光加工系统软件设计,并进行了理论分析和实验验证,取得了大量标刻测量数据.结果表明,在z轴上下300mm范围内,本算法能有效将由于高度与待加工表面形状差异带来的标刻畸变控制在1%左右,并且在各类3维曲面上都得到了很好的加工效果.此研究成功实现了在自由3维曲面上利用动态聚焦技术完成各种表面加工的工作,并通过优化算法有效减少了畸变.In order to mark the target image on an arbitrary curved surface with high quality, it is necessary to convert the typesetted 2-D data into 3-D data so that the processing trajectory data of the specific galvanometer can be formed. On the basis of a large number of experimental measurements and calculations of laser scaling, the field-prioria least square conformal map (FPLSCM) algorithm was proposed to minimize distortion of arbitrary free-form surfaces. The practical software design of laser processing system based on a 3-D galvanometer was completed. The theoretical analysis and experimental verification were carried out. A large number of calibration measurement data were obtained. The results show that, in the range of 300mm above and below the z axis, this algorithm can effectively control the calibration distortion caused by the difference between the height and the shape of the surface to be machined at about 1%. And good processing results have been obtained on all kinds of 3-D curved surfaces. This research successfully accomplishes various surface processing tasks on free 3-D curved surface by using dynamic focusing technology. The distortion is effectively reduced by optimization algorithm.

关 键 词:激光技术 激光加工 曲面参量化算法 自由曲面加工 

分 类 号:TN249[电子电信—物理电子学]

 

参考文献:

正在载入数据...

 

二级参考文献:

正在载入数据...

 

耦合文献:

正在载入数据...

 

引证文献:

正在载入数据...

 

二级引证文献:

正在载入数据...

 

同被引文献:

正在载入数据...

 

相关期刊文献:

正在载入数据...

相关的主题
相关的作者对象
相关的机构对象