检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:匡政 张明义[1] 白晓宇[1] 王永洪[1] 闫楠 朱磊[1] KUANG Zheng;ZHANG Ming-yi;BAI Xiao-yu;WANG Yong-hong;YAN Nan;ZHU Lei(College of Civil Engineering,Qingdao University of Technology,Qingdao 266033,China;College of Environmental Science andEngineering,Qingdao University,Qingdao 266071,China)
机构地区:[1]青岛理工大学土木工程学院,山东青岛266033 [2]青岛大学环境科学与工程学院,山东青岛266071
出 处:《岩土工程学报》2019年第10期1882-1892,共11页Chinese Journal of Geotechnical Engineering
基 金:国家自然科学基金项目(51708316);中国博士后科学基金项目(2018M632641)
摘 要:利用光纤光栅传感技术,对10根GFRP抗浮锚杆进行现场拉拔破坏性试验,研究了风化岩地基中GFRP抗浮锚杆的承载性能与变形特性。试验结果表明:发生滑移破坏的锚杆杆体、锚固体荷载-位移差曲线高于同型号发生断裂破坏的锚杆;锚固长度接近临界锚固长度的试验锚杆荷载-位移差曲线上升较平稳;增加杆体直径有助于提高锚杆承载能力、限制杆体位移并且降低杆体、锚固体的位移差。此外,杆体横截面轴应力沿锚固深度呈“反S型”分布,由孔口沿锚固深度方向递减;锚杆轴向界面剪应力沿锚固深度呈先增大后减小的趋势,且剪应力在锚固体内按斜向上方向由第一界面传递至第二界面。最后,利用剪应力分布简化模型求得杆体、锚固体位移差与发生滑移破坏的锚杆试验结果较为一致,可为GFRP锚杆的推广应用提供理论基础。Through the field pullout destruction tests on 10 GFRP anti-floating anchors using the fiber bragg grating sensing technology, the bearing capacity and deformation properties of the GFRP anti-floating anchors in decomposed rock foundation are investigated.The test results show that the load-displacement difference curve of the anchor body and anchorage body of the GFRP anchors in the slip failure model is higher than that in the rupture failure model.The load-displacement difference curve of the anchor body and anchorage body with the anchorage length which is close to the critical one rises steadily. Increasing the diameter of the anchor body is beneficial for improving the bearing capacity of anchors, limiting the displacement of the anchor body and reducing their displacement difference.Additionally, the distribution of the axial stress on the cross-section of the anchor body, which decreases along the anchorage length, shows a reversed S form along the direction of anchorage length.The shear stress of the axial interface increases firstly and then decreases along the direction of anchorage length, and it transfers from the first interface to the second interface with an oblique upward direction.Finally, the displacement difference of the anchor body and anchorage body, calculated by the simplified model for the distribution of the shear stress, is similar to that of the GFRP anchors in the slip failure model.The research results may provide the theoretical foundation for the application of GFRP anchors.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:52.15.242.179