检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:许贝 裴毅强[1] 秦静[1,2] 刘懿[1] 王晨晰 郭瑞涛 XU Bei;PEI Yiqiang;QIN Jing;LIU Yi;WANG Chenxi;GUO Ruitao(State Key Laboratory of Engines,Tianjin University,Tianjin 300072,China;Internal Combustion Engine Research Institute,Tianjin University,Tianjin 300072,China)
机构地区:[1]天津大学内燃机燃烧学国家重点实验室,天津300072 [2]天津大学内燃机研究所,天津300072
出 处:《内燃机工程》2019年第5期38-45,共8页Chinese Internal Combustion Engine Engineering
基 金:国家自然科学基金项目(51676136)~~
摘 要:运用激光诱导荧光法(LIF)定量分析了缸内直喷汽油机单孔喷油器喷雾撞壁的二维油膜特性。研究发现:燃油在壁面上向油膜铺展的方向聚集,并在边缘形成较厚的油膜。高喷射压力有助于形成质量较小且厚度较薄的油膜,同时减小喷射脉宽能进一步降低燃油附壁率。增加撞壁距离能同时减小油膜质量和油膜面积,然而油膜的平均厚度并未减小,对油膜蒸发并没有明显的促进作用。将喷射角度从15°增加到45°能够显著减少油膜质量和平均厚度。The two-dimensional oil film characteristics of the single-hole injector spray wall impingements in a direct injection gasoline engine were quantitatively analyzed by the laser induced fluorescence method.Results show that the fuel accumulates on the wall in the direction of oil film expansion and forms a thicker oil film on the edge.High injection pressure helps to form an oil film with a lower mass and a thinner thickness,while reducing the jet pulse width can further reduce the fuel adherence rate.Increasing the wall impingement distance can simultaneously reduce the oil film quality and the oil film area,but can not reduce the average thickness of the oil film,so there is no obvious promotion effect on the oil film evaporation.Increasing the spray angle from 15°to 45°can significantly reduce the oil film quality and average thickness.
分 类 号:TK411[动力工程及工程热物理—动力机械及工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.200