检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:丁常坤 郑彦朴 杨炯 DING Changkun;ZHENG Yanpu;YANG Jiong(Guangzhou Zhiyuan Electronics Co.,Ltd.,Guangzhou 510660,China)
机构地区:[1]广州致远电子有限公司
出 处:《现代信息科技》2019年第16期31-32,35,共3页Modern Information Technology
摘 要:电池内阻的测试,主要是利用一组交流信号通过待测电池,提取出电池两端的交流信号幅值,利用电子开关鉴相器对测试信号进行矢量分离,最终得出所测的电阻值。很多场合对于电池内阻的测试有较高的精度要求。不同的电池,其内部的阻值也不一样,有几mΩ至十几kΩ的跨度,所以在这个范围内,均要实现电池内阻的有效测试。利用PSD技术高信噪比的测试特点,能很好地实现微弱信号的检测,因而能很好地实现电池内阻的测试。The test of battery internal resistance is mainly to use a group of ac signals through the battery to be tested,take out the AC signal amplitude at both ends of the battery,use electronic switch phase detector to conduct vector separation of the test signal,and finally get the measured resistance value. In many cases,high accuracy is required for the measurement of battery internal resistance. Different battery,its internal resistance is also different,spans ranging from several mΩ to more than ten kΩ,so in this range,to achieve the effective test battery internal resistance. Using PSD technology,its high signal-to-noise ratio test characteristics,can well achieve weak signal detection,so it can well achieve the battery resistance test.
分 类 号:TM934.1[电气工程—电力电子与电力传动]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.28