装配式保温混凝土空心剪力墙接缝热桥区热工性能分析  

Analysis of Thermal Performance of Joint Thermal Bridge of Prefabricated Thermal Insulation Concrete Hollow Shear Wall

作　　者：胡孝华[1] 王丽雯 HU Xiao-hua;WANG Li-wen(Anhui Chuzhou Vocational and Technical College,Chuzhou 239000,China;Tianjin Jianyuan Engineering Design Consulting Co.,LTD.,Tianjin 300000,China)

机构地区：[1]安徽滁州职业技术学院,安徽滁州239000 [2]天津建源工程设计咨询有限公司,天津300000

出　　处：《节能技术》2019年第5期447-450,共4页Energy Conservation Technology

摘　　要：在装配式墙体结构中引入玻化微珠保温混凝土空心剪力墙,对其热工性能进行了测试。研究结果表明:当环境温度上升后将使墙体的传热系数也明显增大,对墙体孔洞进行填充后能够减小传热系数,接缝热桥宽度增加将引起墙体传热系数增大的现象。采用50 mm厚的挤塑聚苯板作为墙体热桥的外保温结构能够显著减小墙体传热系数。在同样的温度工况下,未填充聚氨酯的FHSW-A1热桥与附近部位的表面温度都比填充了聚氨酯的FHSW-A2墙体表面温度更高。墙体FHSW-A2的热桥区域具有更集中的热流。采用挤塑聚苯板对FHSW-B的热桥作为外保温结构时,能够有效减小热桥与墙体之间的热阻差。The thermal performance of the glass beads insulated concrete hollow shear wall was tested.The results show that the heat transfer coefficient of the wall increases obviously when the ambient temperature rises,the heat transfer coefficient can be reduced by filling the hole of the wall,and the heat transfer coefficient of the wall increases when the width of the thermal bridge of the joint increases.Using 50 mm thick extruded polystyrene board as the external insulation structure of the wall thermal bridge can significantly reduce the heat transfer coefficient of the wall.Under the same temperature condition,the fhsw-a1 thermal bridge without polyurethane and the surface temperature near the site are both higher than that of the fhsw-a2 wall with polyurethane.The thermal bridge area of wall fhsw-a2 has more concentrated heat flow.The thermal resistance difference between the thermal bridge and the wall can be effectively reduced when the thermal bridge of fhsw-b is used as the external thermal insulation structure by using extruded polystyrene board.

关 键 词：保温混凝土 空心剪力墙 热桥区 实验测试 热工性能 

分 类 号：TU398.2[建筑科学—结构工程]