检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:郑仁平 杨青慧[1] 张怀武[1] ZHENG Renping;YANG Qinghui;ZHANG Huaiwu(State Key Laboratory of Electronic Thin Films and Integrated Devices,University of Electronic Science and Technology of China,Chengdu 610054,China)
机构地区:[1]电子科技大学电子薄膜与集成器件国家重点实验室
出 处:《电子科技》2019年第12期1-5,共5页Electronic Science and Technology
基 金:国家自然科学基金(61021061,51272036,51472046,51002021,61131005);国际合作基金(2012DFR10730,2013HH0003)~~
摘 要:在自动电平控制系统中,常用功率反馈电路存在一个主要限制:调幅动态范围受限于电平检波器和相关电路,使其远远低于线性调制器的功率可变范围。文中介绍了一种双耦合双混频中频信号功率反馈电路,使检波器只需检测固定中频信号的功率大小即可反馈调节射频输出信号的功率幅度。经测试,电路射频输入信号在2~4 GHz变化时,得到的中频信号频率固定不变,等于晶振信号54 MHz。线性调制器的衰减量在0~31.5 dB变化时,中频信号功率与射频输出信号功率成良好的线性关系,满足预期的设计要求。In ALC system,there is a major limitation of commonly used power feedback circuits:the amplitude modulation dynamic range is restricted by the level detector and associated circuitry,which is typically much lower than the power variable range of the linear modulator.This paper introduced a dual-coupled and dual-mixed IF signal power feedback circuit,so that the detector could feedback and adjust the power amplitude of the RF output signal only by detecting the power of the fixed IF signal.The test showed that when the RF input signal of the circuit changed at 2~4 GHz,the obtained IF signal was fixed,which was equal to 54 MHz of the crystal signal.And when the attenuation of the linear modulator changed from 0 to 31.5 dB,the IF signal power had a good linear relationship with the RF output signal power,which met the expected design requirements.
关 键 词:自动电平控制 功率反馈 检波器 双耦合 双混频 固定中频
分 类 号:TN702[电子电信—电路与系统]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222