0.8THz再生反馈振荡器的仿真模拟研究  

Study of 0.8 THz regenerative feedback oscillators

作　　者：李天一[1] 孟维思 潘攀[1] 蔡军[1] 邬显平[1] 冯进军[1] 闫铁昌[1] Li Tianyi;Meng Weisi;Pan Pan;Cai Jun;Wu Xianping;Feng Jinjun;Yan Tiechang(National Key Laboratory of Science and Technology on Vacuum Electronics,Beijing Vacuum Electronics Research Institute,Beijing 100015,China)

机构地区：[1]北京真空电子技术研究所微波电真空器件国家级重点实验室

出　　处：《强激光与粒子束》2019年第12期35-39,共5页High Power Laser and Particle Beams

摘　　要：随着太赫兹技术的发展,高频率、大功率的太赫兹辐射源一直是国内外研究的热点。再生反馈振荡器作为一种新型太赫兹源器件,具有可行性高、功率大的优点。基于0.8 THz太赫兹波成像系统的需求,采用折叠波导慢波结构,对再生反馈振荡器进行设计与研究。首先对0.8 THz折叠波导慢波结构进行设计并使用CST微波工作室中的本征模求解器进行参数优化,再通过CST粒子工作室中的PIC仿真模块对整管进行热特性仿真,验证了方案的可行性,仿真结果显示,最终可产生60 mW的稳定输出信号。With the development of terahertz technology,high-frequency and high-power terahertz radiation sources have been the focus of researching all over the world.Based on the requirement of 0.8 THz terahertz wave imaging system,the regenerative feedback oscillator is designed and studied by using folded waveguide slow wave structure(SWS).In this paper,the SWS of 0.8 THz folded waveguide is designed and optimized by using the eigenmode solver in CST Microwave Studio.Then the oscillator is simulated and verified by PIC solver in CST Particle Studio.In the initial exploration stage of THz,regenerative feedback oscillator has the advantage of high feasibility and high output power.The simulation results show that a stable output signal of 60 mW can be generated.

关 键 词：再生反馈振荡器 太赫兹 折叠波导 PIC模拟 

分 类 号：TN124[电子电信—物理电子学]