Experiment and Simulation for Controlling Propagation Direction of Hydrofracture By Multi-Boreholes Hydraulic Fracturing  

作　　者：Chenpeng Song Yulong Chen Jiehao Wang 

机构地区：[1]National and Local Joint Engineering Laboratory of Traffic Civil Engineering Materials,Chongqing Jiaotong University,Chongqing,400074,China [2]Department of Energy and Mineral Engineering,EMS Energy Institute and G3 Center,Pennsylvania State University,University Park,PA 16802,USA [3]School of Energy and Mining Engineering,China University of Mining and Technology,Beijing,100083,China

出　　处：《Computer Modeling in Engineering & Sciences》2019年第9期779-797,共19页工程与科学中的计算机建模（英文）

基　　金：This paper is supported by the National Science Foundation of China(No.51604051);the National Science Foundation of Chongqing(No.cstc2018jcyjA2664);the China Scholarship Council(No.201708500037).

摘　　要：Hydraulic fracturing has been applied to enhance CBM production and prevent gas dynamical hazard in underground coal mines in China.However,affected by in situ stress orientation,hydrofracture can hardly continuously propagate within coal seam but may easily extend to the adjacent roof-floor strata,causing ineffective permeability enhancement in coal seam and increasing the risk of gas transfinite during mining coal.Thus,it is very necessary to artificially control the propagation direction of hydrofracture and make it well-aligned in large scale in coal seam.In this study,a method for controlling propagation direction of hydrofracture by multi-boreholes is investigated by theoretical analysis,laboratory experiment and numerical simulation.And this is followed by an on-site test in an underground coal mine to verify this method.Firstly,stress intensity factor at the hydrofracture tip is analyzed where pore pressure is taken into consideration.Results show that the pore pressure is able to increase the stress intensity factor and reduce hydrofracture propagation pressure.Based on this,a method of hydraulic fracturing using multi-boreholes to control hydrofracture direction is proposed.Afterwards,laboratory experiments are conducted to explore the impact of pore pressure on hydrofracture propagation.The experimental results agree with the theoretical analysis very well.Later on,a series of numerical simulations are performed to examine the influence of principal stress difference,the angle between assistance drillholes and the maximum principal stress,and the fluid pressure of the assistance drillholes on hydrofracture propagation.Finally,an on-site test in an underground coalmine is practiced where this proposed method is used to enhance the CBM production.Results show the scope of the hydro-fracture resulting from the multi-boreholes hydraulic fracturing method increases 2.7 times compared with that of conventional hydraulic fracturing.And gas production rate also increases 4.1 times compared with that of convent

关 键 词：Coalbed methane underground coalmine hydraulic FRACTURING PORE pressure multi-borehole 

分 类 号：TE3[石油与天然气工程—油气田开发工程]