检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:李新明[1,2] 孔令伟[2] 郭爱国[2] LI Xin-ming;KONG Ling-wei;GUO Ai-guo(School of Civil Engineering and Architecture,Zhongyuan University of Technology,Zhengzhou,Henan 450007,China;State Key Laboratory of Geomechanics and Geotechnical Engineering,Institute of Rock and Soil Mechanics,Chinese Academy of Sciences,Wuhan,Hubei 430071,China)
机构地区:[1]中原工学院建筑工程学院,河南郑州450007 [2]中国科学院武汉岩土力学研究所岩土力学与工程国家重点实验室,湖北武汉430071
出 处:《岩土力学》2019年第12期4685-4692,4702,共9页Rock and Soil Mechanics
基 金:国家自然科学基金青年基金项目(No.51509274);国家自然科学基金重点项目(No.41430634);河南省高等学校重点科研项目计划(No.15A560013);河南省高等学校青年骨干教师资助计划项目(2019GGJS142)~~
摘 要:通过GDS三轴试验系统对经历3种卸荷速率损伤后的原状南阳膨胀土样进行再加荷不排水三轴伸长剪切试验,同时考虑了超固结比与固结状态的影响。试验结果表明,膨胀土再加荷剪切力学特性与初始卸荷速率有关。在相同的轴向应变下,初始卸荷速率越小,其偏应力单调越小。在主应力方向改变前后,其应力-应变关系曲线斜率显著变化。相同固结方式与超固结比状态下,孔隙水压力均表现为先增大后减小趋势,孔隙水压力峰值应变随卸荷速率增大而减小。无论是等压固结还是K0固结,初始卸荷速率越大,不排水剪切强度越大。膨胀土样经历了初始卸荷损伤后,再加荷常规三轴伸长试验所得剪切强度均低于无损伤时的强度。以膨胀土破坏强度所得损伤度SD低估了卸荷速率对膨胀土的损伤程度,建议采用孔隙水压力峰值强度进行膨胀土边坡设计计算。原状膨胀土力学性状随卸荷速率损伤的演化规律受卸荷阶段轴向应变大小及裂隙性综合影响。To study the mechanical characteristics of unloading rate damage effect for Nanyang undisturbed expansive soil, the unloading-reloading undrained triaxial shear test was conducted with three unloading rates(0.02 kPa/min, 0.2 kPa/min and 2 kPa/min) through the GDS triaxial test system. The effect of over-consolidation ratio and consolidation state have also been studied. Test results showed that the shear mechanical properties of expansive soil are related to the initial unloading rate. Under the same axial strain, the deviatoric stress is smaller with lower initial unloading rate. The slope of stress-strain curve changed significantly before and after the principal stress direction rotation. Under the same consolidation state and over-consolidation ratio, pore water pressure increased first and then decreased. Peak pore water pressure strain decreases as the unloading rate increases. As the unloading rate decreases, the tangential modulus of the undisturbed expansive soil decreases monotonously. The higher the initial unloading rate, the greater the undrained shear strength. After the initial unloading damage of expansive soil sample, the shear strength obtained by reloading conventional triaxial elongation test was lower than that of non-damage soil sample under both isotropic consolidation and K0 consolidation. The damage degree SD obtained by the failure strength qf of expansive soil greatly underestimated the damage degree of the damage rate to expansive soil. It is recommended to use the strength of peak pore water pressure qumax to design and calculate the slope of expansive soil. The mechanical properties evolution of undisturbed expansive soil with unloading damage rate is influenced by the axial strain and cracking character.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.21.106.4